Jumping to entry point at 0x81080000. LSP 2.10 BETA RELEASE VERSION: 2.10.008.02 U-Boot 1.3.4 (Mar 2 2009 - 11:50:39) I2C: ready DRAM: 128 MB NAND: NAND device: Manufacturer ID: 0x2c, Chip ID: 0xd3 (Micron NAND 1GiB 3,3V 8-bit) Bad block table found at page 524224, version 0x01 Bad block table found at page 524160, version 0x01 NAND device: Manufacturer ID: 0x2c, Chip ID: 0xd3 (Micron NAND 1GiB 3,3V 8-bit) Bad block table found at page 524224, version 0x01 Bad block table found at page 524160, version 0x01 2048 MiB In: serial Out: serial Err: serial Ethernet PHY: GENERIC @ 0x00 Hit any key to stop autoboot: 4  3  2  1  0 Loading from NAND 1GiB 3,3V 8-bit, offset 0x400000 Image Name: Linux-2.6.18_pro500-davinci_evm- Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2026248 Bytes = 1.9 MB Load Address: 80008000 Entry Point: 80008000 ## Booting kernel from Legacy Image at 80700000 ... Image Name: Linux-2.6.18_pro500-davinci_evm- Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2026248 Bytes = 1.9 MB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Starting kernel ... Uncompressing Linux....................................................................................................................................... done, booting the kernel. Linux version 2.6.18_pro500-davinci_evm-arm_v5t_le (a0850430@gtlnxlsf02.gt.design.ti.com) (gcc version 4.2.0 20070126 (prerelease) (MontaVista 4.2.0-3.0.0.0702771 2007-03-10)) #1 PREEMPT Mon Mar 2 12:24:32 EST 2009 CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 Machine: DaVinci DM365 EVM Memory policy: ECC disabled, Data cache writeback DaVinci DM0365 variant 0x0 PLL0: fixedrate: 24000000, commonrate: 121500000, vpssrate: 243000000 PLL0: vencrate: 27000000, ddrrate: 243000000, mmcsdrate: 121500000 PLL1: armrate: 297000000, voicerate: 99000000, vencrate: 74250000 MUX: initialized SPI0_SCLK MUX: initialized SPI0_SDO) MUX: initialized SPI0_SDI MUX: initialized SPI0_SDENA0 CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets Built 1 zonelists. Total pages: 29696 Kernel command line: mem=116M console=ttyS0,115200n8 root=/dev/mtdblock3 rw rootfstype=yaffs2 ip=off davinci_capture.device_type=4 dm365_imp.oper_mode=0 PID hash table entries: 512 (order: 9, 2048 bytes) Clock event device timer0_0 configured with caps set: 03 Console: colour dummy device 80x30 Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 116MB = 116MB total Memory: 113152KB available (3497K code, 712K data, 168K init) Security Framework v1.0.0 initialized Capability LSM initialized Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 DaVinci: 104 gpio irqs DM365 IPIPE initialized in Continuous mode Generic PHY: Registered new driver ch0 default output "COMPOSITE", mode "NTSC" VPBE Encoder Initialized LogicPD encoder initialized Avnetlcd encoder initialized SCSI subsystem initialized usbcore: registered new driver usbfs usbcore: registered new driver hub NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 4096 bind 2048) TCP reno registered VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) squashfs: version 3.1 (2006/08/19) Phillip Lougher JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc. yaffs Mar 2 2009 12:21:46 Installing. SGI XFS with no debug enabled Initializing Cryptographic API io scheduler noop registered io scheduler anticipatory registered (default) davincifb davincifb.0: check_fb_var: calling convert_fb_var_to_osd, var->bits_per_pixel: 16 davincifb davincifb.0: convert_fb_var_to_osd: bits per pixel: 16 davincifb davincifb.0: davincifb_set_par: calling convert_fb_info_to_osd bpp: 16 davincifb davincifb.0: convert_fb_info_to_osd: var->bits_per_pixel: 16 davincifb davincifb.0: convert_fb_var_to_osd: bits per pixel: 16 davincifb davincifb.0: dm_osd0_fb: 720x480x16@0,0 with framebuffer size 675KB davincifb davincifb.0: dm_vid0_fb: 0x0x16@0,0 with framebuffer size 1020KB davincifb davincifb.0: check_fb_var: calling convert_fb_var_to_osd, var->bits_per_pixel: 4 davincifb davincifb.0: convert_fb_var_to_osd: bits per pixel: 4 davincifb davincifb.0: davincifb_set_par: calling convert_fb_info_to_osd bpp: 4 davincifb davincifb.0: convert_fb_info_to_osd: var->bits_per_pixel: 4 davincifb davincifb.0: convert_fb_var_to_osd: bits per pixel: 4 davincifb davincifb.0: dm_osd1_fb: 720x480x4@0,0 with framebuffer size 675KB davincifb davincifb.0: dm_vid1_fb: 0x0x16@0,0 with framebuffer size 1020KB DAVINCI-WDT: DaVinci Watchdog Timer: heartbeat 60 sec davinci_ldc initialized imp serializer initialized davinci_previewer initialized davinci_resizer initialized Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO map 0x1c20000 mem 0xfac20000 (irq = 40) is a 16550A serial8250.0: ttyS1 at MMIO map 0x1d06000 mem 0xfad06000 (irq = 41) is a 16550A RAMDISK driver initialized: 1 RAM disks of 32768K size 1024 blocksize netconsole: not configured, aborting Davinci EMAC MII Bus: probed MAC address is 00:0e:99:02:ca:d8 TI DaVinci EMAC Linux version updated 4.0 Linux video capture interface: v2.00 starting ccdc_reset...<7> End of ccdc_reset...<5>vpfe ccdc capture vpfe ccdc capture.1: vpif_register_decoder: decoder = MT9T001 vpfe ccdc capture vpfe ccdc capture.1: vpif_register_decoder: decoder = MT9P031 TVP514X : nummber of channels = 1 vpfe ccdc capture vpfe ccdc capture.1: vpif_register_decoder: decoder = TVP514X Trying to register davinci display video device. layer=c72e9400,layer->video_dev=c72e9560 Trying to register davinci display video device. layer=c72e9200,layer->video_dev=c72e9360 davinci_init:DaVinci V4L2 Display Driver V1.0 loaded vpfe ccdc capture vpfe ccdc capture.1: vpif_register_decoder: decoder = TVP7002 i2c /dev entries driver nand_davinci nand_davinci.0: Using 4-bit hardware ECC NAND device: Manufacturer ID: 0x2c, Chip ID: 0xd3 (Micron NAND 1GiB 3,3V 8-bit) 2 NAND chips detected Creating 5 MTD partitions on "nand_davinci.0": 0x00000000-0x00360000 : "bootloader" 0x00360000-0x003a0000 : "params" 0x003a0000-0x007a0000 : "kernel" 0x007a0000-0x207a0000 : "filesystem1" 0x207a0000-0x307a0000 : "filesystem2" nand_davinci nand_davinci.0: hardware revision: 2.3 dm_spi.0: davinci SPI Controller driver at 0xc7866000 (irq = 42) use_dma=0 Initializing USB Mass Storage driver... usbcore: registered new driver usb-storage USB Mass Storage support registered. usbcore: registered new driver usbhid drivers/usb/input/hid-core.c: v2.6:USB HID core driver musb_hdrc: version 6.0, cppi-dma, host, debug=0 MUX: initialized GPIO33 musb_hdrc musb_hdrc: No DMA interrupt line musb_hdrc: USB Host mode controller at c7868000 using DMA, IRQ 12 musb_hdrc musb_hdrc: MUSB HDRC host driver musb_hdrc musb_hdrc: new USB bus registered, assigned bus number 1 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected mice: PS/2 mouse device common for all mice davinci-mmc davinci-mmc.0: Supporting 4-bit mode davinci-mmc davinci-mmc.0: Using DMA mode davinci-mmc davinci-mmc.1: Supporting 4-bit mode davinci-mmc davinci-mmc.1: Using DMA mode Advanced Linux Sound Architecture Driver Version 1.0.12rc1 (Thu Jun 22 13:55:50 2006 UTC). ASoC version 0.13.1 AIC3X Audio Codec 0.1 asoc: aic3x <-> davinci-i2s mapping ok ALSA device list: #0: DaVinci DM365 EVM (aic3x) IPv4 over IPv4 tunneling driver TCP bic registered NET: Registered protocol family 1 NET: Registered protocol family 17 drivers/rtc/hctosys.c: unable to open rtc device (rtc0) Time: timer0_1 clocksource has been installed. Clock event device timer0_0 configured with caps set: 08 Switched to high resolution mode on CPU 0 yaffs: dev is 32505859 name is "mtdblock3" yaffs: Attempting MTD mount on 31.3, "mtdblock3" block 103 is bad block 1651 is bad block 3192 is bad nand_update_bbt: Out of memory **>> Block 2015 retired nand_update_bbt: Out of memory **>> Block 1994 retired nand_update_bbt: Out of memory **>> Block 1891 retired nand_update_bbt: Out of memory **>> Block 1806 retired nand_update_bbt: Out of memory **>> Block 1693 retired nand_update_bbt: Out of memory **>> Block 1596 retired nand_update_bbt: Out of memory **>> Block 1482 retired nand_update_bbt: Out of memory **>> Block 1158 retired nand_update_bbt: Out of memory **>> Block 1040 retired nand_update_bbt: Out of memory **>> Block 946 retired nand_update_bbt: Out of memory **>> Block 310 retired nand_update_bbt: Out of memory **>> Block 1803 retired VFS: Mounted root (yaffs2 filesystem). Freeing init memory: 168K nand_update_bbt: Out of memory **>> Block 110 retired nand_update_bbt: Out of memory **>> Block 2090 retired INIT: Entering runlevel: 3 Starting internet superserver: inetd. Starting audio loopback demo Starting video loopback demo main : Enter vpbe_UE_1 : Enter initializing capture device audio_loopback: underrun occurred ths7353_setvalue -start ths7353_setvalue -end ths7353_setvalue -start setting data format Detecting if driver supports COMPONENT input.name = RAW input.name = RAW-1 input.name = COMPOSITE input.name = SVIDEO input.name = COMPONENT ths7353_setvalue -end querystd, erorxxx, val = 1, val1 = 1 error: InitDevice:ioctl:VIDIOC_G_INPUT Error in setting capture format Failed to intialize capture main : Leave MontaVista(R) Linux(R) Professional Edition 5.0.0 (0801921) (none) login: test Login incorrect (none) login: test Login incorrect (none) login: