Custom CC2538 RF PER test

You can use SmartRF Studio 7 to do PER test.

Is there any instruction or document for PER test on custom CC2538?

Thx!

Also, I found this code cc2538_per_test_1_1_0. How can I use this code for our custom CC2538?

As I know, there is no document to describe how to do PER from SmartRF Studio but it is straightforward. You can connect one of your CC2538 to SmartRF Studio and run Packet RX mode. Then, connect another CC2538 to another SmartRF Studio and run Packet TX to send packets. After TX sending finished, you can check PER on RX side. By the way, cc2538_per_test1_1_0 is the out-of-box application run on CC2538DK which require LCD/BTN/LED on SmartRF06. Since you are using CC2538 custom board, I suggest you to use SmartRF Studio to do PER test.

You are welcome.