Part Number: ADC-RTD-CONFIG-CALC Other Parts Discussed in Thread: TINA-TI Hello guys,
I am designing a signal conditioning circuit for RTD ( PT100 sensor)
I designed the circuit and got DC analysis graph Voltage vs resistance as linear
I want a graph between…
Part Number: ADS124S08 Other Parts Discussed in Thread: ISOW7741 , ADS1261 , , ADS1220 , ADS1263 Hello,
I have to measure temperature using RTDs installed within the coils of a 460V AC variable frequency motor.
The current off-the-shelf DAQ module is quite…
Part Number: TMS320F28379D Other Parts Discussed in Thread: SYSCONFIG Hi,
I am using the 28379D MCU
and configuring the ADC on CPU2 using sysconfig.
However, I am getting the following warning message when I try to add the ADC to CPU2.
"The ANALOG PinMux…
Part Number: IWR6843ISK-ODS i want to use iwr6843isk-ods to get angle information, in the adc format config, should i ues the complex1x or complex2x? or both of them works?
Part Number: AFE7952 Hi,
I find out a good tool in TI; https://www.ti.com/tool/FREQ-DDC-FILTER-CALC
I set Fs=2900MHz, Interleave=1, Fc=2050MHz, BW=1MHz.
I get: Rx band=850MHz, HD2=1200MHz, HD3=350MHz, HD4=500MHz, HD5=1350MHz
"slyt738.pdf" The TI doc. show…
Part Number: AM62X-PET-CALC For the first time boot up , I propose to use the USB0 port + DFU mode , please help double confirm whether attached boot config is correct ?
BR Jingcheng
Part Number: ADS1120 Hi,
in your Application Note " A Basic Guide to RTD Measurements" in section 2.7.1, a circuit is shown for 2 RTDs needing a 5 channel ADC. As AIN2 and AIN3 are shorted together at the RTD inputs, would it be possible to modify…
Other Parts Discussed in Thread: ADS1246 , ADS1220 , ADS1146 Dear sir or madam
I'm looking for an ADC IC for a 2-wire RTD measurement (Pt100). The availability is not that great when I check my available channels such as mouser.ch, digikey.ch etc. Maybe…
Hi Bob,
Thank you for your reply.
I have question about ADC-RTD-CONFIG-CALC .
R_PROTECT, R_MISC_H, and R_MISC_L are for protection in case of short circuit, etc,
In an actual circuit, a 1k or several k resistor should be inserted. Is it correct understanding…
Hi Kevin,
I honestly haven't done something like what you are describing with notably different sample rates but the one thing I don't think would work is to do that on the same input channel unless you are cascading your triggers somehow.
What…