Part Number: CC1310
A customer is using CC1310's sensor controller for ADC sampling, but they need to pull down the ADC input pin before every sampling first in order to discharge a capacitor. Please give your hand to guide how to implement this in sensor…
Part Number: TMP139 Hi Team,
my customer is searching for a temp sensor for DDR5.
spec as below: Vddsp, 1.8V typical, 1.7-1.98V, Vddio 1V typical, 0.95-1.05V, 1MHz I2C and 12.5MHz I3C, 11bit valid data. cover -40~125C. Is TMP139 the most suitable one…
Part Number: AMC6821 Other Parts Discussed in Thread: LM94 Hi, Support Team
Do we have 1 PWM for Fan speed control, and 4 remote temp sensor solution?
if any suggestion, Please advise me.
Part Number: CC2640R2F Hi, I need the guidance on the sensor controller code.
Below code is the execution code of adc data logger sensor controller example :
// Enable the ADC
Part Number: SK-AM62 Hi, My customer has some questions for temp sensors in VTM. According to TRM section 126.96.36.199, there are two sensors (Temp_Sensor_Main0 and 1). Q1) Where the location of each sensor? Q2) Is it ok to consider these sensor value as Tj? If…
Part Number: SK-AM62 Hi, My customer wants to evaluate thermal behavior using SK-AM62. He wants to read VTM temp sensor value from Linux SDK console. Please tell me how to get the sensor value using console command? Thanks and regards, Koichiro Tashiro
Szymon Cmiel said: I see that VCCAD should be from 3V to 5.25V and ADREFHI can be from VSSAD to VCCAD.
Sorry my bad. you are correct about this.
Szymon Cmiel said: I need to knew the lowest voltage on VREFHI at which the temperatures sensors will…
Part Number: MSP430FE4272 Hi team,
My customer is using MSP430FE4272 in their appication, and want to use the 2 channel ADC to monitor external analog signal, meanwhile using the internal temperature sensor. However this device doesn't include mux switching…
Part Number: ADS1220 Hi Experts,
Good day! I am posting this on behalf of the customer.
I use ADS1220 as ADC to assemble pressure and temperature sensor. For cost saving, I use an internal temperature sensor as a temperature source and use a MEMS bridge…