Part Number: PCM3168A Other Parts Discussed in Thread: PCM3168 Hi,
I'm in a project where I need to have 6 different audio communication paths. I need each channel to be able to establish calls to one or several sip phones.
In A, i have an analogic…
Hello,
1) I have query regarding the absolute maximum input that the AFE7900EVM Rx input pin can handle with 0 dB DSA setting( with o dB attenuation) . As for the max full scale power range of the ADC is given up to 17.8 dBm for 30 MHz but here , DSA…
Hello Derek,
Hopefully my re uploaded diagram works.
I was hoping that you would be able to respond, I just didn't want to come across as demanding or dictating who should respond, if perhaps you and another of your colleagues shared the load. I do…
Hi Rob,
Refer to www.ti.com/.../adc-wb-bb
Before using balun, it is also fine to measure with single end with another port 50 Ohm terminated.
Regards,
Shawn
Channamallesh,
Yes, you can use those SMA's to bring in an analog input. You will have to move two resistors to allow this. You can use a transformer board made by TI called the "ADC-WB-BB" that has a transformer with a bandwidth from 4.5MHz to 3GHz.…
Hello,
We have a power calculator that you can use to estimate the average power per rail with different device configurations. Please note that during calibration, you may still see the worst case power numbers in the datasheet, so you should always…
Here is the 153.6MHz sinewave from the CLKout0 output through and ADC-WB-BB balun connected to the CLKIN J9 on the DAC3484EVM. The measurement is taken at the C53/R50 junction as measured to the TP8 GND. Is there something wrong with my setup for the…
Part Number: BEAGL-BONE-BLACK Hello,
we are trying to use a BELA audio cape with a BB and are writing our own code to test the ADC on board the cape (AD7699). We are using the PRU to synchronize timings and are seeing some issue with the SPI bus. The…
Hi Philippe, Hope you are having a nice weekend. I ran sudo /opt/scripts/tools/version.sh to provide you with the configuration of our Beaglebone if that helps at all.
debian@beaglebone:/var/lib/cloud9$ sudo /opt/scripts/tools/version.sh
git:/opt/scripts…