Part Number: ADC08060 Tool/software: Hello,
Please disregard the part # submitted on the header and utilize the following: We have stock of part # ADC0806CIMT and have listed internally as a customer special. Can you review and advise if you ever offered…
Part Number: ADC08060 Other Parts Discussed in Thread: ADS131M04 Tool/software: Hi Sir,
Pls kindly suggest TI P2P solution to replace STPM34TR.
Thanks a lot!
BR,
Sean Liao
Part Number: ADC08060 The datasheet says this part operates from 20MSPS to 70MSPS.
Is there any reason I can't operate this slower with a clock rate of 10MHz?
And does the output Data stay constant and can be read asynchronously at anytime?
Part Number: ADC08060 Other Parts Discussed in Thread: ADS8568 Hello Sir!
I am looking for 12- bit, 8-channel, Single-Supply, SAR ADCs capable of measuring inputs up to +/-15V. Could you please suggest some ADCs according to the above-mentioned requirement…
Part Number: ADC08060 Hi, I'm working to design with the ADC08060. The datasheet seems to have conflicting information regarding the input voltage range.
If I set V_RT and V_RB appropriately according to the specification for min, max individually…
Part Number: ADC08060
Hello
According to it's datasheet, the input resistance of ADC08060 is greater than 1MΩ, but with experiments we saw that it is less than 500 kΩ, what might be the problem? It should be noted that the measurement was done with…
Hi Aseok
The battery and LM8272 will be able to provide the needed current for the reference ladder, but the battery has two disadvantages.
Since the reference ladder current is around 7mA, the battery will eventually need to be replaced or re-charged…
Hi Aseok
The ADC08060 output data updates tOD after the rising edge of CLK. The datasheet specification for tOD is 8.2ns typical and 12 ns maximum. The typical tOH value is 4.2 ns, but no minimum or maximum is specified.
If CLK is at the maximum frequency…
It is mentioned in the datasheet about RC termination of clock line when driving multiple A\D's, that:
This termination should be located as close as possible to, but within one centimeter of, the ADC08060 clock pin.
Further, the termination should…
Other Parts Discussed in Thread: ADS831 , ADS830 , ADC08060 Hello
I need IBIS models(to be used in ti-tina) of the data converters mentioned above.
What should i do?
Thanks.
