Part Number: ADC081C021 Tool/software: Hello,
I have a RTC circuit to continue clock when the system is off, I have also battery monitoring circuit to read battery voltage using ADC081C021. The problem I have faced is when the system is not powered,…
Part Number: ADC081C021 Tool/software: Its datasheet says that the pull-up resistors for SCL/SDA are pulled to the same voltage potential as VA, but they seem to be able to work with up to 5.5V even if AV is 3V as described in Operating Ratings.
Can …
Part Number: ADC081C021 Hi,
I just wanted to confirm that the operating temperature range of the VSSOP version of the ADC = ADC081C021CIMM
is compatible with the operating range -40°C / +105°C ?
In the datasheet of the ADC081C021, the temperature…
Part Number: ADC081C021
Hello,
I have the ADC081C021 and in datasheet on 24 page is Table 2. Slave Addresses. I have question about the vlaue "Floating". It means the same as "MID"? My system will be use half level of power supply on this pins. Will be…
Part Number: ADC081C021
Hi team,
my customer want a low cost low resolution (<8 bit) solution with I2C,
is there any other suitable solution than ADC081C0xx?
if no, please provide the GUI of this device, we want to test the EVM, thanks
Part Number: ADC081C021 Hi experts,
Could you let me know if it is okay that a nearby IC is BGA package and need underfill, then underfill splatter on the ADC081C021?
Best regards,
Hideki
Part Number: ADC081C021 What's the power consumption in the Automatic mode for the higher Conversion Intervals? The datasheet mentions only the power consumption for the highest sample rate. What is the power consumption for the lowest sampling rate…
Part Number: ADC081C021 I have a problem with reading the ADC conversion result in normal mode i.e the address pointer register is set to 0(zero). When I try to read the result, only the first reading returns the conversion result, all the following reading…
Part Number: ADC081C021 Hi Sir
The I2C will go through Isolators & Level Shifter, then into CPU.
For our circuit, application is 24V divided into VIN
Need to adjust the resistance part?
Is Address should be 1010100 ?
Is there need other note in the…