Part Number: ADC08B200 Tool/software: Hi,
I am looking for a 150-250 MSPS ADC (preferably dual channel) with a buffer size of > 3KBtye? (basically looking for a part similar to ADC08B200 with larger buffer size). Would you be able to propose a part…
Part Number: ADC08B200 Other Parts Discussed in Thread: ADC08200 , Hi Ti support team,
we are designing a High speed data acquisition system, below are the requirements.
Sample speed: 10 to 200Msps
VDD=3.3VDC
No.of bits: 10 or above
input type: single…
Part Number: ADC08B200 Other Parts Discussed in Thread: LM8272 Hi Team,
We're received an inquiry from a customer about the value of the choke coil between VD and VDR of ADC08B200. At page 8 of SNAA125 document in the link below, the value is 2.5 turn…
This question was resolved outside the E2E forum.
In summary of that discussion, the voltage drop seen is due to the input current flowing into the un-buffered sample and hold circuit at Vin combined with the driving source impedance.
The input current…
Part Number: ADC08B200 I am looking for an ADC for which its datasheet contains similar information to page 25 (figure 46) of the ADC08B200Q datasheet provided below: http://www.ti.com/lit/ds/symlink/adc08b200.pdf I simply would like to input an analog…
Part Number: ADC08B200 Other Parts Discussed in Thread: ADC08B3000 , TSW54J60EVM , TMS320F28027 Dear sir ,
I am working on structural health monitoring project and need to record output from piezo at highest sampling rate possible using a high speed adc…
Other Parts Discussed in Thread: ADC08B200 First my english is not very good........
I must make a pre-trig with an adc08b200. (data before an after an event in the buffer) The most efficient way would be to use a digital comparator at the output of 8 bits…
Other Parts Discussed in Thread: ADC08B200 With the adc08b200, a write to the buffer is initiate with the WEN signal.
There is no specification on the minimum time of WEN signal to start conversion.
My question is:
The WEN signal must be at high throughout…
Other Parts Discussed in Thread: ADC08B200 Hello,
can I use this ADC (ADC08B200) with 22,5 MHz sampling rate? It has no 'lowest sampling rate' specifications.
Kratochvil T.
ADC08B200Q
1. Do you sell a demo board?
2. If no demo board is available can I use a "breakout" board mounted on a ground plane PCB for a prototype?
3. Page 9 of the data sheet specifies a typical RCLK clock rate of 2 Mhz to read the data buffer…
