Dear Rob-san,
I am very grateful for the support of your staff. Thank you very much.
I felt when I heard your advice.I have been to the operation of the test pattern in the same way as during normal ADC operation.
But, perhaps in the process for…
I have two questions regarding the capture buffer.
1. Is it possible to fill the capture buffer in several chunks by pulsing the Write Enable (WEN) signal? I would like to digitize the analog input only when the input level is above a certain limit…
Part Number: ADC08B3000 Other Parts Discussed in Thread: LMH6555 , LMH6554 Hi,
My customer is using ADC08B3000. He wants to input Vin+/- single-end input signal.
The method of inputting single-end signal is showed Figure 46 in datasheet. But customer…
Other Parts Discussed in Thread: ADC08B3000 I am considering the ADC08B3000 for a new development,
Can this device still be recommended for a new design?
What is the expected lifetime of this device - how long can I expect it to be manufactured? …
Other Parts Discussed in Thread: ADC08B3000 I’m having an issue with the 3GSPS ADC (ADC08B3000). I am dynamically changing the ADC’s capture buffer depth from 1K to 4K using the SPI bus. While writing to the capture buffer (WEN = ‘1’), I am monitor the…
Hi Viswa
To synchonize multiple ADC08B3000 devices two conditions must be met. First the internal CLK/2 of all converters must be aligned using the DCLK_RST function. It is challenging to ensure proper setup and hold timing between CLK and DCLK_RST…
Other Parts Discussed in Thread: ADC08B3000 Hallo,
As in topic, I wander if it is posssible to record slow motion waveforms in internal FIFO buffer of ADC08B3000 ?
According documentation the minimal sampling freguency is 500 MHz. Are there any tips…
Hi Ras,
If you want to ADC with data capture buffer we have adc08b200 200MSPS 8 bit adc and we also have ADC08B3000 with is 8 bit 3000 MSPS and also have other devices depending on your resolution and MSPS requirements.
Regards,
Neeraj Gill
Hi Mandar
Regarding your questions about the ADC08B200.
There is no evaluation module available for this ADC, so you would need to design a board around the device. That board could either have a micro-controller on-board or connect to an existing…
Hi Guo
While the ADC08B3000RB hardware includes the expansion header, the FPGA firmware for that EVM does not include support outputting the ADC data on the header.
Also, since the ADC08B3000 is has a data buffer and CMOS data outputs, the maximum…
