Part Number: ADC124S021 Tool/software: Dear Community,
While analyzing the serial timing diagram in the datasheet, I’m unable to determine the values of CPOL and CPHA. Could you please clarify what they are? Additionally, on page 5 (note 2), it states…
Part Number: ADC124S021 Hello everyone, I would kindly like to have some information about the Total Unadjusted Error (TUE) of the ADC124S021 component, how to calculate it, and its numerical value. If powered via a reference with a tolerance of 0.1%,…
Hi Phil,
I understand. The ADS7950 is the best I can find within devices similar to ADC124S021. If you have package types in mind, that would be helpful.
Best, Samiha
Part Number: ADC124S021 What's up TI,
As stated is it OK to keep CS_ grounded permanently and then control single conversions by bursts of SCLK?
The SCLK frequency would be per your spec during the burst, but there would be long periods of SCLK idle…
Hello,
I apologize for the delay, but we have looked through multiple databases in search for this information, but it seems we do not have it. This device was released almost two decades ago, and was part of an acquisition, thus it is possible the information…
Part Number: ADC124S021 Hello guys,
One of my customers is considering using ADC124S021 for their new products.
They have a few questions as the follows.
Could you please give me your reply?
Q1. Can ADC124S021 be used for just one time conversion (not…
Part Number: ADC124S021 Hi team,
I 'm using this type for converting thermistor temperature data .
I have a question about data sampling .
In the case of the figure, where is the analog sampling point?
Regards,
Hitoshi Koide
Part Number: ADC124S021 Hello guys,
One of my customers is considering using ADC124S021 for their new products.
They have the following question about the device.
Q. ADC124S021 uses SCLK as conversion clock. What is the minimum SCLK frequency if it is…
Part Number: ADC124S021 Hi Team.
It seems quite different between these two timing but both of them come from datasheet.
May I ask the following question?
Which timing should customer follow?
What are Z3-Z0 in picture2?
Could you please help to provide…