Part Number: ADC128S022 Tool/software: Is an IBIS model available for this part? It is not listed under the documentation of the part, and I require it for a project.
Part Number: ADC128S022 Tool/software: Hello,
I am going to introduced ADC128S022 in my new design.
I wanted to know whether I can tie CS pin permanently low to ground or not?
I have only one ADC in my CKT and SPI lines are dedicated specially to only…
Part Number: ADC128S022 I'm using the ADC128S022CIMT to monitor 8 different analog sensors. The current algorithm reads all channels every 100 ms. When reading all channels, the measurement shows an accuracy error of around 100 mV. However, if I read…
Part Number: ADC128S022 Hi team,
I understand ADD[2,1,0] decide which input CH is.
In timing chart, it seems that DOUT start before all ADD are decided. If ADD[] level is decided at timing of SCLK rising.
Actually, when ADD[] level is decided?
Best regards…
Part Number: ADC128S022 Hi team,
A customer using the ADC128S022 has found a strange issue. Similar to the original question , but no cause or solution was given in the original problem.
The customer application information:
The VD is powered by a 3V LDO…
Part Number: ADC128S022 I am investigating a scenario where two devices are Chip Selected at the same time.
When I look at the SO from the Client Devices, some of the bits have lower in amplitude than others as shown below (3rd down on the left. It is…
Part Number: ADC128S022 Hello,
Can you let me know what happens if VA ramps slower than VD? What happens if the ESD diodes are turned on?
Will the data be corrupted until both voltages are up or does the part get damaged in some manner.
Thanks, Adam
Part Number: ADC128S022 Other Parts Discussed in Thread: TLA2528 Team,
Customer and us were able to find TI's ADC128S022CIMTX/NOPB as a same functionality alternative to ADI's AD7998B via cross-ref tool. However, the inquiry would be I2C interface…
Part Number: ADC128S022 Other Parts Discussed in Thread: MSP430FR5969
Hello,
I'm using the MSP430FR5969 and it is communicating to ADC128S022 12-bit analog-to-digital converter (ADC) using the SPI protocol. The MSP430FR5969 is the master.
What…
Part Number: ADC128S022 Hello Team,
why is the min. sample rate limited to 50ksps? Can I also use Fsclk=128kHz which results in 1ksps sample rate? We have other SAR ADC (e.g. ADS795x) which can be sampled almost close to DC.
What kind of errors can we expect…
