Part Number: ADC12D1600QML-SP Tool/software: Hi,
When running the calibration cycle, is there a need to disable the inputs to the ADC to minimize noise?
Thanks,
rich
Part Number: ADC12D1600QML-SP Hi,
I can see ADC12D1600CC MLS and ADC12D1600CC MPR have different Op Temp (°C) from the datasheet, but is it the only difference? Also, is there a lower grade ADC12D1600QML-SP which can be used as EM part or ADC12D1600CCMPR…
Part Number: ADC12D1600QML-SP Does the ADC support DES mode with 1:4 Demux and SDR? Basically, we are looking to use the mode in Figure 6 but with SDR instead of DDR. Table 10 does not mention 1:4 Demux mode so it isn't clear if that is supported with…
Part Number: ADC12D1600QML-SP Other Parts Discussed in Thread: ADC12D1620QML-SP , If I have a circuit board that has been fabricated for the ADC12D1620QML-SP, under what conditions, if any, can I use the ADC12D1600QML-SP in its place?
Part Number: ADC12D1600QML-SP Other Parts Discussed in Thread: LMH5401 We are using a ADC12D1600ML A/D converter in our design. It is being driven by a LMH5401 RF Differential Amplifier that is ac coupled to the ADC12D1600ML.
The question came up in…
Part Number: ADC12D1600QML-SP I am looking for information on the AC current of this device to calculate how much noise the device generates on the power rails.
Part Number: ADC12D1600QML-SP Other Parts Discussed in Thread: ADC12D1600 I am looking for data or information on the coupling effects between VIN (I +/-) and VIN (Q +/-) Pins.
My customer is planning to drive the I and Q with different signal types…
Part Number: ADC12D1600QML-SP I have a customer trying to measure ENOB.
Can you share details about the test setup that was used to achieve the results shown in the graph below?
Part Number: ADC12D1600QML-SP Other Parts Discussed in Thread: ADC08D1520QML-SP Hi Team,
Do you have any proton irradiation data for ADC12D1600QML-SP?
If so, is it possible to provide the data?
Regards,
Tom
