Part Number: ADC12D1800 Tool/software: Hi,
I want to interface the LVDS Differential O/Ps of this ADC to Virtex Ultrascale Plus FPGA with HP IO bank.
Below is from ADC datasheet.
Below is Virtex Ultrascale FPGA HP IO bank characteristics ( Link…
Part Number: ADC12D1800
Can you pls share since when ADC12D1800CIUT/NOPB is available in the market and if there is any plans to make it NRND?
I need to use ADC12D1800CIUT/NOPB for a new product with 7-10 year lifetime without any plans for design…
Part Number: ADC12D1800 Tool/software: Hi
I need confirmation related to ADC12D1800 will support Virtex ultra scale + FPGA(XCVU23P-J1760) for Differential signals as below specifications and voltage ranges for both
ADC Spec
Thanks & Regards…
Part Number: ADC12D1800 Hi, I'm using ADC12D1800. connected vbiasq and vbiasl to ground with 100nF capacitors as recommended. Check voltage on the caps and it shows -0.9v , negative voltage. While my input voltages of the ADC are positive.
Checked datasheet…
Part Number: ADC12D1800 Dear Team,
We are using ADC12D1800 in our design ,following are the specifications.
ADC input frequency : DC-500MHz
Sampling mode : Non-Des mode
Sampling frequency : 1.35GHz
We have designed two boards one board is…
Part Number: ADC12D1800 Hi,
I have a customer that is using ADC12D1800CIUT in a design today. Is part number ADC12D1800RFIUT/NOPB a 'better than' product that could be offered as a replacement product? Swap the 'C' device for an 'RF' version with…
Hi Neeraj,
I think that I got something close to what I was looking for. I changed the FPGA code to interleave the samples at the NOSDESIQ mode with the expense of reduced sampling rate.
Thank you for your attention,
Yang
Hi
The ADC12D1800 ADC uses an interleaved calibrated architecture. The I converter channel is made up of two interleaved ADCs, and the Q converter channel is made up of two interleaved ADCs. There are a total of 4 ADC cores on the device.
When run…
Part Number: ADC12D1800RF Other Parts Discussed in Thread: ADC12D1800 Customer wants to decide using ADC12D1800RF or ADC12D1800 for their project requiring 50dB dynamic range. They require SNR, SFDR plot for both devices at below frequencies for finalizing…
Part Number: ADC12D1800 Hi Team,
We have built 5 PCB's using the TI ADC12D1800CIUT/NOPB and they are all producing a similar result with a noise spike at 825MHz, 1/4 of the sampling clock rate 3,300 MHz. A Calibration cycle with no input signal has…
