Part Number: ADC12D800RF Tool/software: I have been using this ADC12D800RFRB board for a few months i am working on partial discharge detection and measurements in high power apparatus using ultra high frequency (UHF) sensor. The UHF sensors are broadband…
Part Number: ADC12D800RF Hi team,
In the ADC12D800 datasheet Table6-30 and 6-15, When Addr: Eh Bit 2：Enable Slave is set to Slave Mode, is it OK to use TimeStamp by setting Addr: Eh Bit 0：Disable Reset to "enable DCLK_RST functionality" and Addr: 0h…
Part Number: ADC12D800RF Other Parts Discussed in Thread: WAVEVISION5 Hi..
I read data from the ADC12D800RFRB model using WaveVision5.
The problem is that setting the HW_TRIG takes too long to respond.
Typical response time is 82 millisecond but…
Part Number: ADC12D800RF Other Parts Discussed in Thread: ADC12D1000 , Hi,Staff
Can I use "ADC12D1000 IBIS Model" for IBIS-Model of ADC12D800RF?
"ADC12D1000 IBIS Model" is described on the ADC12D800RF product homepage.
best regards cafain
Part Number: ADC12D800RF Other Parts Discussed in Thread: ADC12DL3200EVM , TSW14DL3200EVM can you suggest any ADC Evaluation board with FMC connector with sampling rate above 500msps,with lvds interface
Hi Jinseong,
Yes, the ADC12D800RF comes mounted on the evaluation board.
If you need extra, loose ADC parts, then please order those separately.
Regards,
Rob
Part Number: ADC12D800RF Hello, I was checking the parameters of ADC12D800RF and noticed that the analog input full scale range is either 0.6Vpp, 0.8Vpp or 1Vpp. It is lower than other ADCs I have used. I want to make sure I am not misunderstanding. for…
SSIA.
FPGA design for the reference board declares I/O for these 3 undocumented balls, but the datasheet tells nothing.
what are these balls for?
my current guess is,
* CalFail is calibration failure indicator.
* PORen is enable for power on…
Other Parts Discussed in Thread: WAVEVISION5 I installed the WV5 software, and followed the user guide to setup the reference board , the software successfully recognized the board, but Why the DCLK_LOCKED LED is not lit? And after clicking the capturing…
