Part Number: ADC12DJ2700 A customer asked the following questions to register the ADC12DJ2700AAV. Please tell me the details. What is the maximum number that can fit in the tray in which the ADC12DJ2700AAV is packaged?
Part Number: ADC12DJ2700 Team,
We would like to use the timestamp functionality on the ADC. See the snippet of the datasheet below.
It is unclear to me whether the TMSTP implements a LVPECL and LVDS receiver for this differential pair.
The signals to…
Part Number: ADC12DJ2700 Other Parts Discussed in Thread: LMK04828 , LMX2592 , LMH5401 , ADC12DJ5200RF ello,
We have an issue with the Foreground Calibration in the ADC12DJ2700.
Normally, meaning for JMODE_0, JMODE_2, foreground calibration passes.
Also…
Part Number: ADC12DJ2700 Other Parts Discussed in Thread: ADC12DJ3200 Hi,
Good day. Our customer is using the ADC12DJ3600 and they have an inquiry for this. Kindly refer below. ""We use the ADC12DJ3600 in some of our products today, however we only sample…
HI, Neeraj san
I understand that I need to trim where fs / 2-fin is minimized. Also, if you have any problems, please help. Thank you for your kindness.
Regards, cafain
Part Number: ADC12DJ2700 Hi, Staff
I need your help.
This user application uses both INA± and INB± in Single Channel Mode. We are aware that DataSheet strongly recommends the INA± in Single Channel mode.
However, due to the specifications…
Part Number: ADC12DJ2700 Hi, Staff
There is a register that sets the full-scale value of FS_RANGE_A and FS_RANGE_B. (Datasheet SLVSEH9A Table59, and Table60)
When the set value is 0xA000h (40960d), it is FS=800mVpp full scale. For example, if you set the…
Part Number: ADC12DJ2700
Hello.
I want to perform Automatic SYSREF Calibration, but I am wondering at what stage of the Initilization sequence should src_en be set to 1.
In other words, I am curious what normal operation condition means to start Automatic…
Part Number: ADC12DJ2700 Other Parts Discussed in Thread: LMX2582
Hello.
Currently, the output of JESD204 is not displayed. I want help with what is the problem.
The Initial configuration sequence is as follows.
Soft reset (SPI write)
wait ~1ms
JESD…
Part Number: ADC12DJ2700 Hello.
Currently, I configured the board using ADC12DJ2700, and the Device initialization process is in progress.
While monitoring the JESD204B System Status Register (address = 0x208) and finding the cause of the PLL lock failure…