Part Number: ADC12DL3200 Tool/software: Hi Team,
We are working actually with a custom board with the same ADC converter and we experience the same issue sometimes. This is not deterministic and is experienced casually on a channel or on the other one…
Part Number: LMH5401 Other Parts Discussed in Thread: ADC12DL3200 , Tool/software: Hi,
I am using LMH5401 to drive inputs at ADC12DL3200. LMH5401 gets differential inputs from a demodulator. Below is the circuit being used
Demodulator Output will have…
Part Number: ADC12DL3200 Other Parts Discussed in Thread: LMH3401 , LMH5401 Hi,
I am using ADC12DL3200 part in my custom design. ADC gets input signal (of bandwidth DC to 750MHz) from a demodulator, so I can only use DC couple interface. Demodulator output…
Hello Manoj,
Yes the configuration looks valid, you can also pre generate config files for these parts using their respective gui's as a starting point.
To synchronize across multiple devices you will need both sysref and strobe, essentially strobe…
Part Number: ADC12DL3200 Hello,
It appears that, in some cases, the ADC is sending incorrect data over the LVDS interface.
Here is an example of noise acquisition with the presence of incorrect data (temporal view) using dual-channel mode and 3.2Gsps…
Part Number: ADC12DL3200 Hi,
We are using ADC12DL3200 in our custom design in Dual channel mode.
Data Lanes A & C are being used for Input-A and lanes B & D are being used for Input-B. As per datasheet, it is mentioned to length match all the data lanes…
Part Number: ADC12DL3200 Dear Sirs,
in a new design we're using two ADC12DL3200 to acquire 3 RF input channels. The clock frequency can be selected between 2 and 3 Ghz.
The first ADC has the INA and INB connected to RF input channels and the four data…
Part Number: ADC12DL3200 Hello,
We are using ADC12DL3200 in Dual Cuannel mode on our custom board, there is a spur at the frequency fs/2-fin.
It seems that it is relevant to the mismatches due to the interleaving.
There are registers at 0x310...0x315…
Part Number: ADC12DL3200 Hi team,
in the evaluation board of the ADC12DL3200, the analog inputs INA +- and INB +- are inverted.
The figure shows the schematic: the output 1 of the balun 1 (pin 3) is connected to the INA+ (pin A4) and the output 1 of the…