Part Number: ADC16DX370 Tool/software: Hi, I have a question regarding the input frequency response bandwidth of ADC16DX370RMET. The plots in the datasheet all stops at 10MHz. Does that suggest the frequency response does not go down to the actual DC…
Part Number: ADC16DX370 Other Parts Discussed in Thread: LMK04832 We have a module design with an ADC16DX370 running at 368.64 MHz, connected to a Xilinx Ultrascale+ FPGA. We have several ADC modules that run fine, but we are seeing strange, yet consistent…
Part Number: ADC16DX370 Other Parts Discussed in Thread: THS4521 Team,
The ADC16DX370 has a Nominal resistance of 100 Ohms at the sampling port Vin+, and Vin-.
What is the tolerance of that 100 Ohms Resistance? At ambient and at temperature.
I need…
Part Number: ADC16DX370 We have a design using the ADC16DX370. We're enabling the ADC test pattern through the DATA_CTRL register. We're seeing the output as 0, 26328, 0, -26328, but the datasheet says the pattern should be 0, 26280, 0, -26328. Is the…
Part Number: ADC16DX370 Team,
I have a customer trying to calculate power dissipation in the ADC16DX370. From the datasheet, we see the consumption per channel of 800mW, but what is the dissipation for the overhead of the device? I see the parameter…
Hello again Dan,
I have been able to confirm with a second instance of the FMC144 in the exact same HW/SW setup that both ADC16DX370 chips respond correctly to SYSREF. Therefore, there is no issue with ADC chip programming, and there must be an electrical…
Part Number: ADC16DX370 Hi,
Tried verifying that JESD link latency is fixed between ADC16DX370 (on FMC142) and KC705 FPGA JESD Rx core. I am not bothered about exact latency value, I just want to confirm if the latency remains constant on reset or powercycle…
Part Number: ADC16DX370 Device ADC16DX370RMET need US re-export license required?
If the parameters shown below are met or exceeded for the part ADC16DX370RMET with US ECCN 3A001. a. 5. A
if US re-export license is required pls support written/email…
Other Parts Discussed in Thread: ADC16DX370 Hi,
We are using ADC16DX370 in our design. For this IC, whether SYNC+ and SYNC- signals are compulsorily to be routed as differential? Can we use only SYNC+ as a single ended signal, connecting SYNC- to ground…
Other Parts Discussed in Thread: ADC16DX370 Hello,
I am using the ADC16DX370 and I only need channel A. What should I do with Vinb+, Vin-, Vcmb and its two output lanes? I read in the forum that for other ADC leaving the unused channel floating is not…
