Part Number: ADC3222 Hi team,
The datasheet introduces single ended clocking input.
While, the datasheet doen't specify input clock amplitude for single ended CMOS. What is recommended amplitude for single ended clocking?
Best regards,
Shota…
Part Number: ADC3244 Other Parts Discussed in Thread: ADC3222 , Tool/software: Hi,
I am using ADC3244 and ADC3222 ADC's in my custom board. Pls let us know the reference design for the AMD/Xilinx family.
Looking forward for the response.
--Regards…
Part Number: ADC3222 Hello,
The datasheet specifies that this ADC does have a "chopper" function to improve 1/f noise.
Yet I can't find specification of how good it is with chopper enabled.
The provided graphs do not have good enough resolution…
Part Number: ADC3222 Hi,
My customer got stuck making test pattern. Could you please tell me the basic procedure? He uses single-wire, and dither is off. He says he observes 100000000000 after setting register 0Ah to 01h. Do you come up with potential…
Part Number: ADC12DS080 Other Parts Discussed in Thread: ADC3222 , Hi,
I have a question about ADC12DS080 and ADC3222.
1. Each has the following description.
- ADC12DS080: Full Power Bandwidth (-3 dB Corner) 1000MHz
- ADC3222: Analog input bandwidth…
Part Number: ADC3222 In its datasheet there writes 0.7 Vpp nominal for LVDS for CLK input pins. Can we drive these pins through a standard LVDS, HR pins of ultrascale+ familiy FPGAs, configuring pins as LVDS ?
In ADC322x EVM they had used a 1:4 transformer…
Part Number: ADC3222 Hi
Pls. advise what are the recommended constraints for matching of DCLK (Intra pair – between P to N, at mils) and between the DCLK to other lanes (A0,A1,B0,B1,FP).
At my design DCLK is 64MHz.
Thanks!
Part Number: ADC3222 Hi,
I am using ADC3222 in my receiver design and I encountered a problem:
The input signal is a baseband signal (I/Q data) with symbol rate of 400 kHz and the sampling clock frequency is 21 MHz
I have performed few tests and…
Part Number: ADC3222 Hi, Ti.
I'm designing schematic abou ADC3222.
In ADC3222 datasheet chapter 9.3.2, you describe how to connect LVDS line about CLKP/CLKM ( Add 0.1uF and 100ohm).
Can the same circuit be applied to other circuits?
Show attached…
Other Parts Discussed in Thread: ADC3242 , ADC3241 , ADC3222 , ADC3221 Hello E2E, Please let me know how much their INL and DNL. I could not find them from datasheet.
Regards, ACGUY
