Part Number: ADC32RF55 Hello,
Is there a way to do a complete register dump from the eval board software for a given configuration. That will go through the 10 steps in the datasheet to get it programmed? Similar to the "Export Register Map" in the…
Part Number: ADC32RF55 Other Parts Discussed in Thread: ADS54J40 , TI-JESD204-IP , Hello,
I was previously using the ADS54J40 and TI-JESD204-IP.
I would like to use ADC32RF55 in my new development.
Is this device compatible with TI-JESD204-IP…
Part Number: ADC32RF55 Other Parts Discussed in Thread: , ADS54J40 , LMK04828 , LMK04832 Hello,
I'm testing with the ADC32RF55. I extracted the ADC registers from the ADC3xRF5xEVM and configured them, but I'm not getting any output from the FPGA's TI…
Part Number: ADC32RF55 Other Parts Discussed in Thread: LMK04828 , ADS54J40 , , TI-JESD204-IP Hello,
I previously used ADS54J40, and the clock was supplied as VCXO 100MHz to LMK04828 to generate SYSREF, JESD Clk, ADC Clk, etc. to be used for ADC and…
Part Number: ADC32RF55 Other Parts Discussed in Thread: LMK04828 , ADS54J40 , TRF37D73 , , LMK04832 ADC32RF55_LMK04828.pdf
I previously used ADS54J40 and LMK04828.
The hardware structure is as follows:
LNA(TRF37D73) -> VGA(THS7530PWP) -> ADC(ADS54J40…
Part Number: ADC32RF55 Tool/software: Hello team,
My customer is only going to use INA of this device.
Should we connect INB1P/M and INB2P/M to GND?
Also should we leave unused DOUT4 - 7 floating? DOUT is Tx, so customer thinks floating should be…
Part Number: ADC32RF55 Hello team,
This is related to my previos thread below. My customer only use single channel of this ADC, and want to know how to configure JESD lane setting.
https://e2e.ti.com/support/data-converters-group/data-converters/f…
Part Number: ADC32RF55 Hi,
In the 50ohm term, the data sheet's register map at 0x7B states, "Both registers need to be set to the same value."
When selecting the 50ohm term for INA1 and INA2 in ADC3xRF5xEVM_v2.1.2.exe, the register log shows that…
Part Number: ADC32RF55 Tool/software: Hello.
Regarding the GPIO configuration for the ADC32RF55, I would like to set it up as described in Table 7-14 of section 7.3.4.3 to calibrate 2 ADC pairs at a time using a GPIO trigger.
However, the timing…
Part Number: ADC32RF55 Other Parts Discussed in Thread: ADC12DJ2700 , LMK04832 Tool/software: Dear Person in Charge,
I am going to make a board using ADC32RF55 and evaluate its performance. I have a question about the timing of SYSREF and device clock…
