Part Number: ADC3564 Other Parts Discussed in Thread: ADC3664-SP , LMK04832 Hi,
I’m currently working with the ADC3564 and have a few concerns regarding its configuration and behavior. I’d appreciate your insights on the following points:
Bit…
Part Number: ADC3564
Hi,
I’m currently working with the ADC3564 in our custom hardware design. Unfortunately, my initial post regarding this part seems to have been removed from the TI forums, and I’m unable to retrieve any of the previous discussions…
Part Number: ADC3564 Tool/software: Hello, The datasheet Table 9-6 specifies t4. The unit of the t4 is clock cycle. This clock cycle means one cycle of CLKP/M? Best regards, K.Hirano
Part Number: ADC3564 In our system, the reference voltage is supplied by connecting an external 1.6 V reference directly to the VREF input (External voltage reference (VREF), 8.3.3.2 of the datasheet).
Please tell me the accuracy of the reference…
Part Number: ADC3564 Hello, After NCO frequency is written in the register via SPI, how much time does it take for the NCO to change its frequency to the written frequency from the previous frequency? Best regards, K.Hirano
Part Number: ADC3564 Other Parts Discussed in Thread: ADC3664EVM Hello, My customer would like to evaluate ADC3564. However, I can not find ADC3564EVM at TI web. Does TI have an EVM for ADC3564? Best regards, K.Hirano
Part Number: ADC3564 Other Parts Discussed in Thread: ADC3664 Hi team,
Want to check the INL/DNL spec in our datasheet:
Top page shows INL: ±1.5 LSB, DNL: ±0.5 LSB
EC page shows INL: ±2.6 LSB, DNL: ±0.9 LSB
Please confirm which number is correct…
Other Parts Discussed in Thread: ADC3663 , ADC3662 , ADC12J4000 , ADC3664 , ADC3564 I am using an FPGA ( Zynq UltraScale+ MPSoC ZCU102 Evaluation Kit (xilinx.com) )to close a 25Mhz power converter and would like a high speed ADC for a voltage mode control…
Hi Troy,
The X through any components means that the component is not populated, allowing us to provide multiple operational modes via HW modifications. If you are only wanting a single channel, then you can power down the channel using the GUI. If…
