Part Number: ADC3661 Tool/software: We are starting a new design which will require an ARM processor and two ADC's (one fast & one slow). We would like to request support in selecting the best MCU and ADC's for our application. The application is for…
Part Number: ADC3661 Tool/software: The datasheet for the ADC3661 (SBAS991B, revised March 2022) has minimum and nominal numbers for tCD on page 13, but doesn't have maximum numbers.
It seems like we need a maximum tCD over the full temperature range…
Part Number: ADC3661 Dear Technical Support Team,
SLVDS for ADC3661 has 2-wire, 1-wire,1/2-wire output mode.
According to each timing diagram, is following output timing from sampling to Digital data correct?
10MSPS = 0.1us for sampling clock. …
Part Number: ADC3661 Hi Team,
Our customer needs help with ADC3661 configuration. Please see the details of his inquiry below.
I need register load sequence to configure ADC3661 analog to digital converter to 2-wire interface in bypass mode. …
Part Number: ADC3661 Other Parts Discussed in Thread: ADC3561 , , ADC3662EVM
Dear Technical Support Team,
I have questions about ADC3661 and ADC3561 evaluation with EVM
1.)
Do you have ADC3661EVM and ADC3561EVM?
According to the website for…
Part Number: ADC3661 Other Parts Discussed in Thread: ADC3662 , ADC3663 Dear E2E Team!
we use ADC3661 in 1-wire SLVDS output bit mapper. ADC digital data output based on DCLKIN, DCLK and FCLK.
Sampling clock falling edge to DCLK rising edge (t PD…
Part Number: ADC3661 Hi,
I've seen that the Stratix IV is used to connect to the ADC366x on the evaluation board.
Is there a possibility to connect the ADC to the 7z020? If so, how?
The 7z020 does neither provide HP banks nor high-speed LVDS.
…
Part Number: ADC3662 Other Parts Discussed in Thread: , ADC3661 Dear All
we plan to use ADC366x 16 bit dual channel ADC for prototyping. From data sheet it is not understood how we can use ADC without any digital filtering (DDC)/decimation.
Our interpretation…
Hi Quirin,
When the 'connected' green status light appears on the GUI, the 'Device Variant' section should read the internal ID of the ADC and auto-select the device it sees connected. If working properly, this is not an option that you should have…
Part Number: ADC3683 Other Parts Discussed in Thread: ADC3681 , ADC3682 , Hi,
the datasheet says that the input clock frequency works with a range of 0.5 to 65 MHz.
How is this correlated to the sampling rate of 65 MSPS?
Is it something like this…
