Part Number: ADS1015 Tool/software: Hi team,
Could you tell the input impedance when the input is single-ended?
Here are other their condition. FSR is +4.096V, LSB = 2mV, sampling speed is 128SPS.
Regards,
Noriyuki Takahashi
Part Number: ADS1015-Q1 Other Parts Discussed in Thread: ADS1015 Tool/software: Hi team，
Harman are currently integrating the ADS1015-Q1 into our software system and have encountered an issue that requires your expertise to resolve.
Here are…
Part Number: ADS1015 Tool/software: In our product we are using ADS1015 with 4 external multiplexer ICs, one for each of the converter's input. As you can see below in the screenshot, we have RC filters of 200R/10n between each external multiplexer and…
Part Number: ADS1015 Tool/software: Hi Sir.
I will plan to use ADS1015 do the sensor detection.
The sensor is 4~20mA current output. I will add 250ohm resistor to do current and voltage converter before analog input.
The maximum input voltage is…
Part Number: ADS1015 Tool/software: Hi,
Did the latest datasheet revision "F "change how unused analog input PINs are handled? Previous Version recommended floating or tying to VDD. The latest revision now recommends floating or tying to GND.
Our…
Part Number: ADS1015 Hello, I am using an ADS1015 to do some basic voltage measurements on two ranges, 0-5V and 0-12V. The ADC VCC is 3.3V, and I am using resistor dividers to adjust both of those inputs into the correct range. The ADC max input voltages…
Part Number: ADS1015-Q1 Tool/software: Hello TI Team,
We want to use ADS1015-Q1 in our design and have following queries:
1. I2C, Alert pins are open drain output can we connect it to 3.3V pull up and keep VDD as 5V?
2. Our analog input range is…
Part Number: ADS1015 Tool/software: Hi Team,
We are planning to use the ADS1015 ADC with the ABT375 Gear-Tooth Sensor, which has a maximum output range of 100-600 mVpp/V. However, the minimum FSR value for the ADS1015 is ±0.256. Given this, will the…
Part Number: ADS1015 Tool/software: Hello, Our customer is requesting a statement of volatility or letter of volatility. Can someone help out with this request? Thanks,
James Fasolino RTX
Part Number: ADS1015 Tool/software: Hello,
We have a new die revision that does not match with parts previously purchased/tested in the past.
The part number is ADS1015IRUGR and was purchased from Digi-key.
The new die markings are "ADS115", maskwork…
