Part Number: ADS1100 Other Parts Discussed in Thread: ADS1114 Tool/software: The first and second pins of the J9 terminal are the input terminals of the 4-20mA sampling circuit. The 4-20mA signal flows through the 120R sampling resistor of the circuit…
Part Number: ADS1100 I have this issue in which several ADS1100 A/D chips have failed in our assembly.
We have a system that runs a test in which it is looking for a zero volt signal on a line. Typically, we get a reading of 0x0000 to 0x0010 from the…
Part Number: ADS1100 Hi there,
Kindly advise if the following STC of ADS1100A0IDBVT are affected as per ADS1100 Selective Inventory Exchange.
1750 (STC: 7651904NF2, 7651908NF2)
1818 (STC: 8031819NF2, 8031812NF2, 8031829NF2)
Thanks,
…
Part Number: TPS7B83-Q1 Other Parts Discussed in Thread: ADS1100 , INA190 Hi all,
We are intended to use the following chips in one of out circuit design
TPS7B83 150-mA, 40-V, Low-Dropout Regulator.
ADS1100 Self-Calibrating, 16-Bit ANALOG-TO…
Part Number: ADS1100 Other Parts Discussed in Thread: ADS112C04 Hi team,
I'm looking for a ADC for research. I thought ADS1100 can meet my request but it seems don't have EVM board. Can you introduce me a ADC with EVM available so I can set my test…
Part Number: ADS1100 how to eliminate nonlinearity when measuring resistance around 0x2aaa? The conversion to DA is around this value somehow frozen :(
Remigiusz,
I haven't heard from you for a while so I thought I'd check on this problem. In my last posts, I thought there might be some issue involving the device receiving some I2C STOP because of the clock timing, or because of some voltage level…
Part Number: ADS1100 Other Parts Discussed in Thread: REF02 , ADS1110 , ADS1118 , ADS1115
Hello there,
my question is directed at AD converters ADS1100 that draw their reference voltage from Vdd. In other words, supply voltage is the reference voltage…
Part Number: ADS1100 Hey everyone,
I've got an ADS1100 hooked up with part number ADS1100A3.
I can write and read to the device, although when writing to the device I send it the following:
ST (Bit 7) = 0
(Bit 6) = 0
(Bit 5) = 0
SC …
For debugging purposes, I extended the "setup read" function to read three bytes from the ADS1100, i.e., the output register and the content of the configuration register.
The configuration register's content is always 0x8F. This confirms that programming…
