Part Number: ADS1119 Dear all, We are using the ADS1119 in our current design, and it is configured to continuous conversion, data rate of 20 sps and we are using the four channels single ended. As expected, the DRDY generates an interrupt at every 50 ms…
Part Number: ADS1119 Other Parts Discussed in Thread: REF5050 , Hi team, We are using ADS1119IPWT to read the analog values from a sensor. The DVDD is set to 3.3V. The AVDD is set to 5V. my input voltage is in the range of 0 -5V. 1). Can I use the internal 2…
Part Number: ADS1119 Other Parts Discussed in Thread: INA333 , Hi, I'm working on a project which involves the measure of whetstone bridge-based sensors (strain gauge). Basically, there are 4 bridges, each one connected to an INA333 amplifier and to…
Part Number: BOOSTXL-ADS1119 Other Parts Discussed in Thread: ADS1119 Hi Experts,
Good day.
I have a customer requesting the GUI of BOOSTXL-ADS1119. As per its user's guide, this SW is should be accessible from its device folder. But upon checking, only…
Part Number: ADS1119 Hi,
I can't find any ADS1119 C code software. If exists, could you please share? I saw a BOOSTXL-ADS1119 example but, there is no source code anywhere.
Regards,
Ender
TRANSLATE with x
English
Arabic
Hebrew
Polish
Bul…
Part Number: ADS1119 Hi, I would like to read all the channels of ADS1119, so as I understand from the datasheet I need to cycle the mux by the configuration register. My doubts are related to the time needed in order to write register and change channel…
Part Number: ADS1119
Hi Experts,
My customer wants to know if ADS1119 does clock stretching on SCL line of I2C bus which is defined in I2C-Bus Specification and User Manual.
https://www.nxp.com/docs/en/user-guide/UM10204.pdf
Due to a problem, customer…
Hi Kazuya,
I believe that your drawing is a mostly accurate representation of what is going on except in the error state the 8th clock falling edge will return SDA back high and the micro will see a NACK at the 9th clock. In the normal case, SDA returns…
Part Number: ADS1119 Hi Experts,
My customer is going to read the conversion data after elapsing 1.04ms after issuing STAT/SYNC command without monitoring DRDY pin or DRDY bit
Single-shot conversion mode
1000SPS
I need your confirmation if this method…
Part Number: ADS1119
Hello,
for my application with ADS1119 I need 4 single ended analog inputs. Is it possible to aquire them with the ADS1119 in continous mode? As I understood the data sheet, the MUX have to be switched each time by command, so that…