Part Number: ADS1231REF Other Parts Discussed in Thread: MSP430F5529 , MSP432E401Y Hi Ti,
We have the ADS1231REF eval board. we want to make custom code for pressure sensor measurement. is there source of this eval board for download?
Thanks,
J…
Part Number: ADS1231REF I recently received this board and it looks like it should be easy to use. I tried to go through the calibration mode and then after completing that I try to weigh and all I get on the display is "LG G". I am trying to display…
Part Number: ADS1231REF Hi Team,
a customer is looking for the GUI of the ADS1231REF. could you please point me to the right direction?
Thank you!
BR,
Stefan
Part Number: ADS1231REF Hello,
I have a ADS1231REF board that freezes anytime I use any buttons. If I am in scale mode and try to calibrate, the lcd freezes. If I am in analysis mode and I try to change the unit, it freezes as well. Once the display…
Part Number: ADS1231REF Other Parts Discussed in Thread: ADS1231 , Hi . We are interfacing a strain gauge to this evaluation board . We are unable to measure at lower input ranges in uv range . What is the minimum resolution this device can support in…
Part Number: ADS1231REF Other Parts Discussed in Thread: ADS1231 Hi,
I am not understanding how the capacitors C38 and C39 are selected in design.
What is the criteria to select these capacitors in input signals and what will be the cutoff frequency…
I believe the SCLK and DOUT signals are working as intended using the onboard MCU. I've attached an image of my oscilloscope below. The blue signal is SCLK and the yellow is DRDY/DOUT. Before each bit is shifted out, DRDY/DOUT goes high for a signfiicant…
Hi Sang Cho,
Welcome to the E2E forum! It is difficult to give you an exact number as this will depend if you have connected a load cell to the ADS1231REF and the current draw of the load cell.
In the past we have used 9V adapters with 1A output,…
Hi user3378701,
Welcome to the E2E forum! I'm glad to hear you figured out the functionality of the CW setup on the ADS1231REF. If you have further questions, feel free to ask them in a new post.
Best regards,
Bob B
