Other Parts Discussed in Thread: LDC1612 Tool/software: Hello!
We are working on using sinusoidal AC excitation or PWM signal for the bridge circuit (not bridge chopping) to measure the real part of the sensor formed by an RC network. The frequency we…
Part Number: ADS1234 Tool/software: Hi,
I am an electronics technician here at the University of Bristol and am supporting researchers who are wanting to build a sensing probe that measures soil impact/density using three (3) strain guage and one (1…
Part Number: ADS1234 Tool/software:
I'm using the ADS1234 to measure a bridge. The reference voltage is 2.5V. If I use a GAIN of 64, what will be the maximum voltage that the ADC can read? Is the calculation 0.5Vref/64?
Second question…
Part Number: ADS1234 Tool/software: Hi I am using the ADS1234 component, with three channels connected differentially. I want to connect the fourth channel in a single-ended configuration to measure a temperature resistor. The gain I am using is 64. Should…
Part Number: ADS1234 Other Parts Discussed in Thread: TMUX1109 Tool/software: Hello,
I am planning to use ADS1234 to read 4 load cells each has 6 wire output. I am not sure how to use REFP and REFN inputs. Each load cell has its own REF output and ADS1234…
Part Number: ADS1234 Other Parts Discussed in Thread: ADS1232REF , ADS1232 HI,
Currently we are working on load cell using ADS1234, for this implementation any example is there?
and how to go ached with this module can you suggest me an any idea.
thank…
Part Number: ADS1234 Other Parts Discussed in Thread: ADS1232 Hi guys !
I am studying electrical engineering in second year and for a university project I want to connect 4 loads cells to the main board. Since I want 4 inputs, I decide to use ADS1234…
Part Number: ADS1234 Other Parts Discussed in Thread: ADS124S06 , ADS1232 Background:
Using an ADS1234
Generally it works well i.e. low noise and accurate.
I have a 4 layer board with a ground plane with appropriate decoupling of supplies (I believe). …
Part Number: ADS1234 Hey, I was wondering if i could get someone to confirm if i an miss-reading/understanding a table of if there is a mistake in the datasheet available from yourselves. Table 8-2 "ADS1234 Input Channel Selection With A0 and A1 " shows…
Part Number: ADS1234 Hi guys !
I am a EE student and here is my pcb. I juste have one question about the digital and analog separation. I am hesitating between these 2 options:
1) have separated analog and digital ground planes only on the back layer…
