Part Number: ADS1235-Q1 Other Parts Discussed in Thread: ADS1235 Dear Team,
I am working with the ADS1235 IC on a custom board and attempting to read the ADC conversion data.
Initially, I was able to successfully read the Device ID and write the configuration…
Part Number: ADS1235-Q1 Other Parts Discussed in Thread: ADS1235
I am currently looking to replace an EOL ADC (Cirrus CS5532) with a similar 24-bit device. We have used many tens of thousands of the CS5532…
Part Number: ADS1235-Q1 Other Parts Discussed in Thread: ADS1235 Tool/software: Dear Team,
we are using 24-bit ADC - ADS1235QWRHMRQ1.
for our requirement FIR filter cut off frequencies are: 150, 80, 40, 20, 10, 5, 2.5 Hz, but in our current selected…
Part Number: ADS1261-Q1 Other Parts Discussed in Thread: ADS1235 , ADS1260 , ADS1260-Q1 , ADS1261 Tool/software: Dear Support,
I would like to ask for your help in choosing a voltage reference/LDO for the ADS1235/ADS1260 converter as Vref. Rating: Automotive…
Other Parts Discussed in Thread: ADS1235-Q1 Hi
i am using ADS1235-Q1 for reading Hall Effect Sensor input.
i am seeing variation in the internal die temperature reading of the chip.
When input voltage at AIN2 is changing from (0 to 4.95)V , die…
Other Parts Discussed in Thread: ADS1235-Q1 , ADS1235 , ADS1261 Hello,
We've made our own PCB with the ads1235-q1 on it. At the moment I'm trying to control the ads1235 over SPI, but I don't get any answer form it. Therefore I try to figure out if it…
Hi Matthew Love,
None of your pictures came through - see below. Can you reattach? Make sure to check the thread after you post to make sure the pics are visible and clickable (clicking on them usually makes them larger and more readable). Or you can…
Hi Darren,
Not all QFN packages are the same. Almost all QFN packages that I'm aware of in PADC are standard QFN packages that do not have wettable flanks and have a standard finish of NiPdAu (Nickel-Palladium-Gold). The ADS124S08 uses a standard QFN…
Part Number: CDCE6214 Other Parts Discussed in Thread: , ADS1235 Hi TI team We're looking to use the CDCE6124 in a clock servo application where we use it to syntonize all local clocks (ADC @ 7.3728MHz , MCU @24 MHz, and MAC/PHY @ 25MHz) to a network…
Hello Miyashita-san,
Q1: This information is not readily available, but typically, internal resistor dividers will be in the range of 100kOhm to keep power consumption low. The VCOM signal is not available outside the device, and the resistor values…
