Part Number: ADS1247 After a Sync Command is sent (04h) with a PGA setting of 160 SPS, the spec indicates that data will be ready 6.240mS after.
If I send RDATA (12h) after 6.240mS from the sync, will I have to wait another 6.240 mS to get an accurate…
Part Number: ADS1247 Other Parts Discussed in Thread: ADS1248
Hello! We have some ADS1247 that don't work correcty in our devices. Such IC have Reference value 2.038 (the lowest in datasheet but applicable) V instead of typical 2.047 - 2.049 and some…
Part Number: ADS1247 Other Parts Discussed in Thread: ADS1262 , ADS1248 Hi.
I want to make universal input board using ADS1247.
How to design circuit for mA, Voltage, mv & RTD ?
Please provide circuit design.
Part Number: ADS1247 Hi Sir,
We are using ADS1247 and Pt100 to measure temperature, but when charging, there will be a sudden change in the measured temperature value (the end equipment have battery inside).
Here is my schematic:
As u can…
Part Number: ADS1247
Hi, support team
My customer has the questions as follow:
When using ADS1247 external reference voltage, if I float REFOUT/REFCOM pin, I want to know the answers to the following questions：
1. What impact will it have on chip…
Part Number: ADS1247 Hi there,
I am trying to take a single-ended measurement with an ADS1247, but whatever I do it always returns the same value.
Here's my schematic:
I have set the registers on the ADS1247 as follows:
PGA=1
Data output…
Part Number: ADS1247 Team,
In the data sheet on page 18, the "Data rate error" is indicated in a diagram:
-Could you please clarify the meaning? -Is this the error that is caused exclusively in the digital area of the ADC? or is it the sum of all…
Part Number: ADS1247 Hi Sir,
Our customer report that they using ADS1247 to connect to PT100 for temperature measurement. But the measured temperature is 10°C lower than the actual temperature (which measured by the temperature calibration instrument…
Part Number: ADS1247 We designed a testing board with ADS1247IPW. the board can start normally at temperature higher than 0 degree C. But the board starting time was longer and longer and can't be started at temperature -8 degree C. the board started…
