Part Number: ADS1255 Hello Team,
My customer used ADS1210 before, but now 1210 is going out of production. The official website suggests ADS1255 instead, but ADS1210 supports synchronous sampling. The datasheet of ADS1255 does not say whether it supports…
Part Number: ADS1255 Other Parts Discussed in Thread: OPA2189 , ADS1235 , ADS1261 Hello, do you have an app note about driving the input stage on the ADS1255? There is not really sufficient information in the datasheet. It doesn't even specify the acquisition…
Part Number: ADS1255 I have an application where I need a very low noise A/D converter and I need to be able to sync it with 6 other converters so they sample at exactly the same time and at the same rate. I'm looking at the ADS1255. It has a sync…
Part Number: ADS1255 Other Parts Discussed in Thread: ADS1261 , ADS1260 , ADS1235 Hi,
Customers have been using the ADS1255 / 6 for their bridge sensors for many years. Is there an ultra-low noise ADC to replace this ADC? We are selecting an ADC for new…
Part Number: ADS1255 Other Parts Discussed in Thread: ADS1256 Hi
I am developing a driver for ads1255 to read analog data using spi with pic18f46k80 microcontroller
i have followed the sample code from internet but not working
And also i have read datasheet…
Part Number: ADS1255 Hi team,
I want to confirm that ADS1255 while in a single-end design, the AINCOM need directly connect to VREF or AVDD?
And the cap between VREFP/VREFN need to be 47uf? if 10uf, any influence?
Thanks.
Best regards,
Mia Ma
A
Part Number: ADS1255 Hello. In my application ADS1255 works with my microcontroller throught shrort cable with 200 Ohm resistors on data lines:
And i cant correcntly configure it via SPI. In different cases different registers may configures differently…
Part Number: ADS1255 Other Parts Discussed in Thread: ADS1262 , ADS1235 , ADS125H02 , ADS125H01 Hi there,
I am using the ADS1255 to measure an amplified signal from a load cell.
Normally I would measure between 0-5V BUT some Loadcells output zero offset…
