Part Number: ADS1258 Tool/software: Hi, I am working on the ADS1258 and I have questions about the Channel Data Read Direct command.
First, I am sending a register write command (the first three bits are "011"=Register Write Command) in order to configure…
Part Number: TMS320F28379D Other Parts Discussed in Thread: ADS1258 Tool/software: Hello,
I had created a thread earlier, but there was very little response on it, so I have created a new thread here. I am using the TMS320F28379D controller, which I…
Part Number: ADS1258-EP Other Parts Discussed in Thread: ADS1258 Tool/software: Hi,
Is there an option to identify an ADC via an ID or serial number over SPI?
My customer is open for other solutions to identify each ADC individually.
Thanks
Part Number: TMS320F28379D Other Parts Discussed in Thread: ADS1258 , Tool/software: I used the ADS1258 EVM software to verify the ADC output values for known input voltages and prepared an Excel table as shown below. Could you please check if the formulae…
Part Number: ADS1258-EP Other Parts Discussed in Thread: ADS1258 Tool/software: I am reading channels AIN0-15 and all SYSRED channels which comes out to 21 channels in auto-scan mode. from the ADS1258-EP datasheet I calculated my sample rate from the…
Part Number: ADS1258 Other Parts Discussed in Thread: ADS131E06 , ADS131E08 , ADS127L11 Tool/software: Greetings Community,
I need advice on data logging multiple ADCs and/or ADC Channels to interface 40+ Strain Gauge Values on an MCU that can show…
Part Number: ADS1258 Hi TI,
We have design based ADS1258IRTCR
We have problem of reading external ADC input 16 Ch Single ended or DIFF - all read are not correct close to ~0V
We succeed to read SYSRED Internal measurements : REF - GAIN - TEMP…
Part Number: TMS320F28379D Other Parts Discussed in Thread: ADS1258 Tool/software: Hello,
I am working on the TMS320F28379D controller and I want to interface it with the ADS1258 via SPI. The main task is to read the default register values of the ADS1258…
Part Number: ADS1258 Other Parts Discussed in Thread: ADCPRO Hi Team,
I am using ads1258. I am using it in fixed scan mode and single ended input. I am passing the Register Write Command and register data through SPI. The data is sending properly…
Part Number: ADS1258 I have configured the circuit as shown below. Are there any problems? Please help. In particular, since this is my first time using an ADC with a mux part, I am not sure if it is right to add a buffer like that.
The customer's requirements…
