Part Number: ADS1262 Hi TI team,
In ADS1262 does all the filter provide 50Hz and 60Hz rejection and for what data rates.
In datasheet
Section 9.3.10(Pg 43)
"The FIR filter provides simultaneous rejection of 50-Hz and 60-Hz power-line frequencies with…
Part Number: ADS1262 Dear sir,
Request you to help me with the following queries:
I am Programming the IC from FPGA.
note:
1.RESET/PWDN pin always high, and using internal reference ,continuous conversion, gain 32, mux reg-- AIN0(POSITIVE ),AIN1(NEGATIVE…
Part Number: ADS1262 Other Parts Discussed in Thread: TPS60403 , LM27762 , TPS61220 I'm revisiting this project. I have the ADS1262 working with my loadcell on a 0-5v supply, but would like to run it off a single cell battery.
I found this document…
Part Number: ADS1262 Follow the steps for the calibration command given in Section 9.4.9.8 as follows:
1. write INPMUX (24'h460067), configure the channel;
2. write the REFMUX (24'h4F0012), configure reference voltage;
3. write MODE0 (24'h430000…
Part Number: ADS1262 Dear Bryan Lizon ， I have been studying the “Fundamentals of Precision ADC Noise Analysis“ you wrote before recently.There are a few questions about ENBW.
First，ENBW is determined by the bandwidth of anti-aliasing filter…
Part Number: ADS1262 Hi TI Team,
When I was going through "Fundamentals of Precision ADC Noise Analysis"(slyy 192).I couldn't understand how you calculated ENBW of Antialiasiing filter and Sinc4 filter(Chapter 2.2).
ENBW of Antialiasing…
Part Number: ADS1262
1. Configure the negative voltage pins of the ADS126 acquisition terminal as AINCOM:GND, and configure the positive voltage pins as AIN1 and AIN0 respectively. The voltage can be stably measured as -2.499V and 2.499V.
2. Configure…
Part Number: ADS1262 I am trying to get a better understanding of the output data from the ADS1262. I have a +1V signal connected between AIN0 and AINCOM. The output does change when the signal level changes, however the data the ADC is getting back does…
Part Number: ADS1262 I’d very much appreciate a design review before I send a datalogger board I’ve laid out for manufacturing. I’ve marked areas where I’m uncertain of my design decisions.
The board that employs two ADS1262 chips…
