Part Number: ADS1278 Hi Team,
How to configure the through the spi.What are pin we need to connect?
pls support me and give the any reference code.....!
Thanks and regards
ARAVIND
Part Number: ADS1278-SP Tool/software: Hi,
Is the range for AVDD 4.75V to 5.25V as specified in the pinout descriptions or would a 3.3V rail be acceptable? There is no recommended operating condition for the voltage outside of the 4.75V to 5.25V, so…
Part Number: ADS1278 Other Parts Discussed in Thread: ADCPRO , I am using the ADS1x7xEVM-PDK EVM board + ADCPro and when the unit is set to MULTISCOPE Mode with 2.5V (Vref), High Resolution I get an offset in the resulting data collected at 128Ksps of…
Part Number: ADS1278-SP Other Parts Discussed in Thread: ADS1278 Tool/software: Please may provide me which is the unit for limits of GAIN and INL parameters reported in the Radiation Test Report "ADS1278-SP Total Ionizing Dose (TID) Radiation Report…
Part Number: ADS1278 Other Parts Discussed in Thread: INA851 , ADS1261 , THS4551 , ADS1261EVM I am interested in using the ADS1278 to measure the output of a wheatstone bridge with four variable resistors. I see the example circuit in figures 89 and 90…
Part Number: ADS1278-SP Other Parts Discussed in Thread: ADCPRO Although the test eval board has non-rad hard components, we plan to shield all the components except the device under test (ADS1278-SP) with Pb brick.
This Pb shielding will prevent radiation…
Part Number: ADS1278 Other Parts Discussed in Thread: THP210 , THS4521 In the ADS1278 datasheet, figures 89 and 90 show recommended FDA circuits for driving channels of the ADC. Why is the recommendation to put the 49.9-ohm resistors before the feedback…
Part Number: ADS1278-SP Tool/software: Dear TI, We have an application with a low frequency differential input signal (typical 200mHz, max. 5Hz). The Datasheet tells that a 1nF to 10nF capacitor should be used directly across the analog inputs. Since…
