Hello Nikolas,
Thanks for your post. It sounds like you have configured everything correctly to use the daughterboard of the ADS1278EVM-PDK as a standalone board. I have a feeling that the port expanders (U7 and U8) are powering-on such that the some…
Part Number: ADS1278EVM-PDK Hello,
So, I have been seeing data off of the MISO line to my micro-controller, I just haven't been able to get the timing correct. I am supplying SCLK = 3.3333 MHz and CLK is left at the on board 27MHz. I am using High speed…
Other Parts Discussed in Thread: ADS1278 , ADS1278EVM-PDK Hi, I have the same problem as in the thread
USBStyx for ADS1278EVM-PDK
with the same messages. When loading the ADS1278EVM I get these messages:
"Locating Binary file"
"Reading binary…
Hello Ian,
Everything looks correct. Assuming all voltage measurements check out, I think the most likely cause is the driver, specifically the USBstyx. I do not think the plug-in for the -CVAL version of the board had the drivers updated with signed…
Hi Kory,
Thanks for your question.
Have you gone through the following documents? The first one details the installation instructions for ADCPro and the related plug-ins needed for your EVM. I imagine this is relatively straightforward anyway, but…
Part Number: ADS1278EVM-PDK Other Parts Discussed in Thread: ADS1278 , ADCPRO Hello I am trying to interface my ADS1278 EVM-PDK with an NI myRIO using SPI. I am an ME and this is my first time trying to use SPI. I have a few questions to help me start…
Other Parts Discussed in Thread: ADS1278EVM-PDK , ADCPRO Hello,
I've tried multiple times to get the software configured and running correctly. The problem seems to be related to the system not being able to recognize the USB-Modular EVM Motherboard…
Other Parts Discussed in Thread: ADCPRO , ADS1278 I have an older ADS1278EVM PDK. I can't get past the load to the MMB0. I've searched through this e2e and suspect I need the right documentation so that I can get the switches and jumpers right. The 'vintage…
Hello Carlos -
With another look at your screen capture, something looks off. The ADS1278EVM plugin information should have been installed one folder further down.
You can try moving the entire folder 'ADS1278EVM-PDK' into the 'evm' folder. You then…
Part Number: ADS1278EVM-PDK Other Parts Discussed in Thread: ADS1278 Hi,
I have a problem with the SPI interface from the ADS1278.
According to the data sheet, the data MSB is ready to clock into the CPU one CLK cycle after the falling edge of DRDY…
