Hello Keith,
thanks for your comments. I have added a 100Ohm resistor in the input. The bypass caps were located in another part of the schematic sheet, they are present
Regards,
Javier
Part Number: ADS127L11 Other Parts Discussed in Thread: ADS1278 , ADS127L01 Hello,
I will be driving in my design several ADS127L11 in parallel and fully synchronized. Each of the ADS127L11 will have its own isolated supply and will communicate with the…
Part Number: ADS127L11
Hi,
I have an issue with communicating with the ADS127L11 converter. Connection:
4-wire SPI,
external clock 25MHz,
SCLK about 12MHz,
START pin connected to GND,
RESET pin not connected.
Sequence of actions:
reset…
Part Number: ADS127L11 Can ADS127L11 send 32-bit samples in 2 or 3 SPI frames?
We are trying to use ADS127L11 with all 24-bits. and to send the samples to the H743ST32.
The datasheet for the microcontroller mentions the 8 and 16-bit SPI frames, but not…
Part Number: ADS127L11 I'm working on a PCB design where I have 2 ADS127L11's daisy chained.
Figure 8-36 of the data sheet shows an example: The diagram shows each chained SDO->SDI line with a pull up resistor to IOVDD. However, I can't find any…
Part Number: ADS127L11 Other Parts Discussed in Thread: TINA-TI , PSPICE-FOR-TI Hello,
I was glad there is a model for this AD, it makes sense to start learning from it this way. I downloaded TINA-TI.
I have an old original WinXP, It does not work in VirtualBox…
Part Number: ADS127L11 Hello guys,
One of my customers is considering using ADS127L11 for their new products.
At this moment, they have the following questions. Could you please give me your reply?
Q1. Why is 3ohm resistor needed between external capacitor…
Part Number: ADS127L11 Hello guys,
One of my customers is considering using ADS127L11 for their new products.
At this moment, they have the following question about CLK terminal. Could you please give me your reply?
Q. Is it OK to connect CLK terminal to…