Part Number: ADS1282-HT Hello,
In the ASD1282-HT datasheet, the AVDD and AVSS are: AVDD = 2.5 V, AVSS = –2.5 V OR AVDD = 5 V, AVSS = 0 V.
I am designing a system, 175C rated and the DC/DC converters available for this temperature have a maximum…
Part Number: ADS1282-HT Other Parts Discussed in Thread: ADS1282 , ADS1281 Hello,
I want to have on the same SPI, the ADS1282 and a DAC (AD5600) - sharing the same SCLK and DIN.
The problem is that the ADS1282 doesn't have a Chip Select and if I send data…
Part Number: ADS1282-HT Other Parts Discussed in Thread: ADS1282 , ADS1283 Hello,
I am able to write and read the ADS1282 registers, except the register 0x0a (FSC2). I suppose, I can write/change this register because the ADC output is changing but anytime…
Part Number: ADS1282-HT Other Parts Discussed in Thread: ADS1282 Does Fdata in figure 43 or tables in section 7.7,7.9, 7.10, table 20 refer to frequency of input signal or sample rate . if input signal frequency , what if input signal is not one tone…
Part Number: ADS1282-HT Other Parts Discussed in Thread: ADS1282 Hello, TI expert
On this post it seems that ADS1282H can recover from transient overload contidion easier than original ADS1282. Does that mean if there are no overload condion , e.g. very…
Part Number: ADS1282-HT Other Parts Discussed in Thread: ADS1282
Based on the datasheet, it's unclear to me whether the ADS1282 can use the sync command rather than the sync pin when it is in continuous sync mode. The sync pin would be tied high in this…
Part Number: ADS1282-HT Using a single supply of 5V, the reference should also be 5.0V with the Vref+ at 5.0 and the Vref- to gnd? Is this correct? With a differential amplifier driving Vin+ and Vin -, If this voltage went to 0 or 5V can the part tolerate…
Part Number: ADS1282-HT On page 22 of the ADS1282-HT datasheet, the Ron of the input multiplexer switches is given to typically be about 30R. Is there any information based on the manufacturing process regarding the typical tolerance and temperature coefficient…