Part Number: ADS1283 Hello, TI expert
It is found that if geophone keeps shocking for a long time(that means the input of ads1283 is over +- 2.5V), it seems that sometimes ADS1283 will be reset. I am not sure the overrange state is the root cause…
Part Number: ADS1283
Hello, TI expert
An output spectrum test had been done in our custom design for ADS1283. Everything is fine as what the datasheet said, but the 0.1Hz~0.2Hz frequency band. It showes that it is about three times higher than upper…
Part Number: ADS1283 Hi team,
I have two questions.
1. Using ads1283 to collect data, in fir mode, the sampling rate is 250500, 1K, 2K, 4K respectively, is the data output phase fixed?
2. Different sampling rates collect the same sine wave at the…
Part Number: ADS1283 Other Parts Discussed in Thread: ADS1282 , ADS1282-SP Hi,
We will use the ADS1283 for the new project, and we want to get the electrical parameter charger report after we use the ADS1283 about 1 or 2 years, thanks.
Part Number: ADS1283 If I want to calibrate the waveform amplitude at all sampling rates, what is a better method, Can ads1283 conduct Pspice simulation?
Part Number: ADS1283 Other Parts Discussed in Thread: DAC1282 Our application uses multiple devices on the same SPI bus, specifically ADS1283 and DAC1282. At one point, we were concerned about signal contention on the Dout pin, resulting not so much from…
Part Number: ADS1283 Other Parts Discussed in Thread: ADS1283 Dear sir
i would like purchase ads1283 product. with evaluation bord, but no stock when shall get this product? i want address of product developer.
Part Number: ADS1283 Dear support team,
We bought a seismic acquisiton system using the ADS1283 and I was surprised by the phase delay applied by the FIR stages in data.
On section 3 and section 4 (linear phase) detailed in Table 9, the detailed FIR…
Hi Ramesh,
Unfortunately, this is probably not a topic that we have be of much help with. Have you tied searching for companies on the TI Design Network ?
Best regards, Chris
Part Number: ADS1283 My question is as follows ： Using FPGA to communicate with ads1283 to collect analog signal ， After downloading the parameters, the timing of drdy and SCLK is inconsistent with the manual 。
The following two figures are shown ，…
