Part Number: ADS1299EEGFE-PDK Other Parts Discussed in Thread: ADS1299 Tool/software: I am using stm32 to communicate with my ads1299, and I want to know, what is the maximum spi rate of ads1299? Because when I increase the spi rate to 5Mbit/s, the transmission…
Part Number: ADS1299EEGFE-PDK Other Parts Discussed in Thread: ADS1299 Tool/software: Hi All,
Any step by step manual for freshers to use the software for ADS1299 with MMBO which i had bought , the manual given is pretty tough for a beginner to follow…
Part Number: ADS1299EEGFE-PDK Other Parts Discussed in Thread: ADS1299 Tool/software: Hi,
I recently purchased the ADS1299EEG-FE with part number of 296-34948-ND and when I connect the adapter, it becomes extremely hot. After testing the board with a multimeter…
Part Number: ADS1299EEGFE-PDK Other Parts Discussed in Thread: ADS1299 Tool/software: Hi, I want to acquire EEG from a single electrode connected to PIN36 of J6 header - which is CH1 - AIN1P. I want to use SRB1. Where do I connect the signal BIAS and…
Part Number: ADS1299EEGFE-PDK Tool/software: Hello E2E forum, I am using ADS1299EEGFE-PDK I interface ads1299eegfe with nrf52840 dk. My register settings are CONFIG1 = 0xD5 CONFIG2 = 0xD0 CONFIG3 = 0xEC and CPHA = 1, CPOL = 0 SPICLK is 8MHZ
I am having fetal…
Part Number: ADS1299EEGFE-PDK Other Parts Discussed in Thread: ADS1299 Tool/software: Hi Team,
Does ADS1299 support test signal generation in single-shot mode? If yes, kindly share the application note for that.
Please find the information below for…
Part Number: ADS1299EEGFE-PDK Tool/software: Hi,
When I was testing, there was always an offset between the waveform I measured and the waveform sent by the function generator. I want to know, when I use the CH1 channel, I connect J6's 36 to my positive…
Part Number: ADS1299EEGFE-PDK Other Parts Discussed in Thread: ADS1299 Tool/software: Hi,
When I was testing ADS1299, I found that the signal was offset through the GUI. I used the waveform generator to generate a square wave with an amplitude of 20mV…
Part Number: ADS1299EEGFE-PDK Other Parts Discussed in Thread: ADS1299 Tool/software: Hi,
I use STM32 to control ADS1299EVM. I want to use the internal square wave test function to test it. I successfully get the signal, but the waveform does not look…
Part Number: ADS1299EEGFE-PDK Other Parts Discussed in Thread: ADS1299 Tool/software: Hi,
There seems to be a problem with the ID register of my test board, its value changed to 0xDF instead of 0x3E, I tried to fix it, I reconnected the power supply,…
