Part Number: ADS130E08
Hello,
I'm developing a device that needs to read data from -4V to 4V (or 2.828Vrms).
According to the following table on the datasheet that is possible.
But when reading other sections of the datasheet I ended up getting…
Part Number: ADS130E08 Other Parts Discussed in Thread: ADS131E08 Hi Team,
I am using ADS130E08 for my application to sample 6 channels simultaneously at 3ksps. My questions are,
1. How can I calculate the required clock frequency for my SPI clock…
Part Number: ADS130E08 Other Parts Discussed in Thread: ADS131A04 Hi Team,
I want measure the current values from power line for my project. I need to have a sampling rate of maximum 5ksps and simultaneous sampling of 3 channels , So I choose ADS130E08…
Part Number: ADS130E08 Other Parts Discussed in Thread: ADS131E08 Hi, everyone
We used the ADS130E08 to make a sample .
But can not read back the chip ID by SPI bus, the START/Reset/PWR_DN/ DIN/DOUT/CLK/ looks fine
if there are any suggestion for…
Part Number: ADS130E08 I have some questions about this device, for which I have to write some software.
The most pressing is: I would like to use READC mode from a RaspberryPi RP2040 MCU (2x Cortex M0+) using DMA. I'm a bit new to directly using SPI…
Part Number: ADS130E08 Other Parts Discussed in Thread: ADS131E08 Hello,
Customers want to use the device with Daisy-Chain connection. According to datasheet, it is described that it can be set by DAISY_IN bit of CONFIG1 register. However, DAISY_IN…
Part Number: ADS130E08
Hello everyone. I'm currently working on a project that makes use of multiples ADS130E08 in daisy chain mode. I was able to setup and read data when utilizing just one board, but, when i try to setup multiple boards (each one…
Part Number: ADS130E08 ADC Reset pin going low for 2uS when there is a disturbance (Ringing Noise) on Main Power supply (15V). May I know TI recommendation to fix this issue?
Part Number: ADS130E08 We are planning to interface ADS130E08 to a DSP with SPI and use EMDA to pull in the data at every 250usec. We'll be connecting multiple ADCs (around 10 ) to one SPI in daisy chain mode.
The concern here is with the bit pattern…
