Part Number: ADS131M03 Other Parts Discussed in Thread: ADS131M04EVM
Hello,
I'm using the ADS131M03 with no problem on all of its features except for " Reading Multiple Registers " command:
A) If I do a repeated single register "0" read…
Part Number: ADS131M03 Good afternoon, everyone! I am doing a student project where I need to get data from a 3 channel ADC ADS131M03 using an Attiny84 microcontroller. My problem is that I can't read any data from any of the registers, and I can't even…
Part Number: ADS131M03-Q1 Hi team,
I'm FAE Jimmy located in TW. My customer meet a problem that burn in time is too long. based on the diagram will need around 200hr.
Would you have any suggestion for this situation? if OK please provide the original…
Hello Dale,
We came across the INA236, which appears to be a promising solution for our current and voltage monitoring needs. It offers the ability to measure both current and voltage, as well as provide power readings, all through the I2C interface. …
Part Number: ADS131M03 I have a question regarding the clock frequency of the ADS131:
We will use ‘High resolution mode’ and the maximum oversampling rate (16384) because that gives the best quality results.
We only need to collect one reading…
Part Number: ADS131M03 Hi team,
My customer is asking about the clock input of this IC. Can you look at the below questions?
1. In low power mode, the IC should accept 0.3MHz～2.08MHz. Would there be any performance deference depending on the frequency…
Part Number: ADS131M03 Hi,
I have an ADS131M03 in my design - and it has been a great ADC so far. I would like to implement a self-check in my firmware and the part has internal test signals as per section 8.3.9 in the datasheet.
When I set CHx_CFG to…
Part Number: ADS131M03 Hi team!
My customer is interested in this IC and has further questions about the noise spec.
Below table is from page15. It is when the master clock is set at 8.192 MHz.
I understand that the modulation clock and the filter clock…
Part Number: ADS131M03-Q1 Hello,
The datasheet states “Connect either SYNC/RESET or DRDY to the MCU to ensure the MCU stays synchronized to ADC conversions.”
Figure 9-2 shows them connected to GPIO on the MCU.
But also says you can use the…
Part Number: ADS131M03-Q1 If we supply 3.3V
Table 8-1 implies for a gain of 1, the maximum voltage that can be read is 1.2V
Customer Support told us that was for differential and to use absolute (from Table 3) would allow maximum 3.3V and to get absolute…
