Part Number: ADS131M04-Q1 Other Parts Discussed in Thread: RM48L540 , , HALCOGEN , ADS131M04 , ADS131M04EVM Tool/software: Dear Team,
I am working on the RM48L540 and trying to interface it with the ADS131M04-Q1 IC for ADC conversion. However, in the…
Part Number: ADS131M04-Q1 On page 30 of the datasheet it says: "The delta-sigma modulators of the ADS131M04-Q1 require CLKIN to toggle after tPOR to begin working."
Does the above statement mean that I need to wait until AFTER tPOR to start toggling…
Part Number: ADS131M04-Q1 I'm trying to decide which is better to use to determine if new samples are ready to read: the DRDY pin or the DRDY register in the status register.
I want to configure the /DRDY pin to assert only if ALL channels have a new…
Part Number: ADS131M04-Q1 On page 37 of the datasheet it says:
Words can be 16, 24, or 32 bits. The word size is configured by the WLENGTH[1:0] bits in the MODE register. The device defaults to a 24-bit word size. Commands, responses, CRC, and registers…
Hi KIRYOUNG YANG,
Welcome to the TI E2E community!
I'm not sure if you have designed and are testing your own circuit board with ADS131M04-Q1 ADC. From your block diagram, you are connecting CAP pin to the GND(AGND), the CAP pin of ADS131M04-Q1 is…
Part Number: ADS131M04-Q1 Other Parts Discussed in Thread: ADS127L18 , ADS127L21 , TINA-TI , ADS127L11 Tool/software: Hello Ti,
I am looking for ADC which is capable of simultaneous sampling and operates at 3.3V, my highest frequency of interest is…
Hi Flip,
One error (a problem with some content) was always showed when I tried to open your csv files. It would be good if you could provide timing plots (/CS, SCLK, DIN, DOUT, /DRDY) captured with a logic analyzer. Did you have a trouble to write…
Part Number: AMC131M03-Q1 Other Parts Discussed in Thread: AMC131M03 Tool/software: hi my doubt is, in the AMC131M03 it will send 5 words of data during read from MCU. since im using 24 bit data length. the 3 adc data will come as 24 bit. i want to confirm…
Part Number: AMC131M03-Q1 Other Parts Discussed in Thread: ADS131M04 , AMC131M03 Tool/software: Hi, I'm using AMC131M03 and ADS131M04 for voltage and current sensing and measurements. are there any SPI driver files or any example file using SPI configuration…
