Part Number: ADS41B29 Tool/software: Measured low frequency response:
For other ADCs (e.g. ads42xxx) there is Application Report SBAA220, describing similar behavior, originating from dual path of HF/LF amplification.
But for ADS41B29 there is nothing…
Part Number: ADS41B29 Other Parts Discussed in Thread: ADS5407 Hi
I am rather curious to know why when I simulate the internal input circuit for AS41B29 as shown on page 26 of the datasheet, I DO NOT get the plots shown on page 48. Either you have…
Part Number: ADS41B29 Other Parts Discussed in Thread: ADS4129 , ADS5463 Dear Expert
There is a curve in the specification that I didn't understand: the relationship between input voltage and SNR. Why does the larger the input amplitude, the lower the…
Part Number: ADS41B29 Hi. I'd like to use this part in my design to capture a 20Mhz analog input signal near baseband. I've created a schematic and would like a review to ensure I've understood the application correctly without posting my schematic publicly…
Part Number: ADS41B29 1.8V CMOS JEDEC standard calls VOL max 0.45V, VIL min 0.63V. This provides 0.18V noise margin.
However, ADS41B29 Low level input voltage max is only 0.4V. This is less than the guaranteed JEDEC VOL.
This makes it incompatible…
Part Number: ADS41B29EVM Other Parts Discussed in Thread: ADS41B29 We have ADS41B29 eval board, using FMC-ADC adapter rev D to connect to Xilinx board. LVDS P on ADC board connects to LVDS N on adapter.
Hi,
I'm trying to set the ADC to CMOS mode. My register settings are:
0x03, 0x03, 0x25, 0x50, 0x3D, 0x80, 0x3F, 0x1F, 0x40, 0xFF, 0x41, 0xC0, 0x42, 0x08, 0x43, 0x00, 0x4A, 0x01
My CLK is 166.66MHz. I cannot see any CLKOUT signal on the pins 4 or…
Other Parts Discussed in Thread: ADS41B29 Hi I m now designing ADS41B29 circuit
The IC have pair input pin but I want to use single input pin
is it possible ?--
INP is signal input ,
INM is GND or 1.5V
Other Parts Discussed in Thread: ADS41B29 , ADS41B29EVM Hi !
Can anybody tell me how I can control the ADS41B29 EVM connected to my TSW1400EVM through the 'High Speed Data Converter' GUI?
Is there anywhere I can find a schematic ot TSW1400 EVM?…
Other Parts Discussed in Thread: ADS41B29 Hi
I have question concerning ADS41B29 maximum voltage rating for the analog inputs. According to the data sheet absolute maximum rating for INP and INM is “Minimum (1.9, AVDD + 0.3V)”. How to understand this…
