Part Number: ADS42JB69EVM
Hi,
If we buy ADS42JB69EVM, is TSW14J56EVM included?
Or do we need to buy TSW14J56EVM in addition to ADS42JB69EVM?
Best Regards,
Kuramochi
Part Number: ADS42JB69EVM Other Parts Discussed in Thread: LMK04828 , Hello,
I'm developing a custom FPGA board (with a Kintex 7) that communicates with the ADS42JB69EVM board and ADC using the FMC connector. I'm going to use the LMK04828 included in the…
Part Number: ADS42JB69EVM Other Parts Discussed in Thread: ADS42JB69 , LMK04828 I would like to use FPGA instead of USB to program ADS42JB69 and LMK04828.
How does SPI_D[7:0] from FMC connector map to SPI interface of ADS42JB69 {sdout, sclk, sdata, sen}…
Part Number: CC1310 Other Parts Discussed in Thread: ADS42JB46EVM , , ADC32RF45EVM
Hello Everyone,
I want to connect an cc1310 from TI with the ZCU102 Evaluation Board to receiver an heartbeat or a short burst msg over RF(~868 MHZ). I’ve read in another…
Hi,
So on the eval board the additional R-C-R is recommended on the datasheet. That Additional R-C-R is not on the Eval board . Only the C is present. This usually leads me to believe that during testing you did not find that R-C-R necessary or effective…
Part Number: ADS42JB69EVM On the evalboard for the output of the 1.8V u use an EMIFIL,FB2 and FB3, type of filtering. I am a little concerned because only one manufacture makes the part. Is there an alternative? Can I use a ferrite bead as with the 3…
Part Number: ADS42JB69EVM Other Parts Discussed in Thread: TSW14J50EVM Hello, Jim
The TSW14J01 board is used for jesd204b reference deisgn , but I can't search any information with it? where to buy?
Part Number: ADS42JB69EVM Other Parts Discussed in Thread: LMK04828 , ADS42JB69 , DAC38J84 hello, Jim
I have test this board today, after power up, the dclk4 output a frequency signal , but the phase noise is very poor(about -75dBc/Hz@1KHz), after connected…
Part Number: ADS42JB69EVM hello everyone,
who can support the orcad file of this board? It takes too much time to draw a schematic. in other wise, the fpga reference design is based on vivado2016.1, but I have updated my vivado to 2017.3, how to build…