Part Number: ADS5263 We are planing to use ADS 5263 devices, but we do not have an experience to handle LVDS DDR signals.
We are planning to use Altera Stratix IV to receive the LVDS signals from ADS 5263.
Stratix IV is in TSW1400EVM. So we would…
Part Number: ADS5263 Hello Sirs,
I have a quick and simple question: could somebody suggest me an heatsink for the ADS5263?
I´m trying to find one that suits to the component but apparently I can´t.
Thanks in adavance
Best Regards
Giulio…
Part Number: ADS5263EVM Other Parts Discussed in Thread: ADS5263 Hello everyone,
In ADS5263 evm , can I externally program ads5263 through the external SPI taps available on the ADS5263 evm as highlighted in image below, without using USB provided on…
Other Parts Discussed in Thread: ADS5263 I am trying to get this dev board to work connected to a Cyclone V GT development kit. I am using the TI ADC to HSMC adapter board to connect the boards. Currently I have reduced the sampling rate to 20MHz on 1…
Other Parts Discussed in Thread: ADS5263 , ADS5263EVM , THS4131 Hello,
I have a question about the ADS5263 differential Input Voltage and its relationship with the input frequency. On the datasheet (page 46) I see the graph that describes it and my…
Other Parts Discussed in Thread: ADS5263 , ADS5263EVM What ground wiring pattern do you recommend? "Figure 105. Layout of Board", p.73 of ads5263's datasheet shows common ground plane both for analog (AGND), digital (LGND) ground pads of ads5263. We are…
Hi Olu.
In the begining of this topick about ADS5263, i posted formula
Noise Floor = FS - SNR - 10*Lg(fs:(2*BW))
where: FS - full scale signal (for ads5263 FS = 16 dBm); SNR - signal to noise ratio (for ads5263 SNR = 84.1 dBFS); BW - the band in…
Hi Giulio,
For your 1) question:
Since you may use 2 wire, 8x serialization mode for ADS5263 device.
Then the propagation delay Tpdi is listed on the ADS5263 data sheet page 12:
Tpdi = (ts/4) + tdelay
and tdelay (min=6.8ns, typical=8.8ns,…
Part Number: ADS5263EVM Other Parts Discussed in Thread: ADS5263 , AFE5809 hello,
I am trying to configure ADS5263 ADC with TSW 1400 capture card ,as per the procedure given on : http://www.ti.com/lit/ug/slau344a/slau344a.pdf
1 . while after selecting…
