Part Number: ADS5295EVM The boards are compatible hardware wise. Only issue is about how to write the VHDL code to interface through software. I am new to this area. So if any expert is out there, please share the code.
Part Number: ADS5295EVM Other Parts Discussed in Thread: ADS5295 Tool/software: Hello,
I am using ADS5295 EVAL Board. I converted the P10 connector to headers and entered the pins of the ALINX AC7020C card with twisted cables.
I want to work with…
Part Number: ADS5295EVM Other Parts Discussed in Thread: ADS5295 Tool/software: I am outputting a 20kHz square wave %50 dty cycle signal with RIGOL's DG832 model signal generator. My upper voltage is 1.2V, my lower voltage is 0.6V DC.
I connected the…
Part Number: ADS5295EVM Other Parts Discussed in Thread: ADS5295 I am trying to connect ADS5295EVM and TSW1400 Board to make it work.
If I connect the USB connector of ADS5295EVM and the USB connector of TSW1400 Board to different USB ports of the same…
Part Number: ADS5295EVM Other Parts Discussed in Thread: ADS5295 The ADC board was made by referring to the circuit diagram of ADS5295EVM. When I applied 50MHz Single Ended Clock to ADS5295, 50MHz Clock was observed on LVDS P/N Pin at ADC Clock Out. Then…
Part Number: ADS5295EVM Dear support team,
may I kindly ask you where to find the verilog source files for the ADS5295EVM when connected to TSW1200 or TSW1400 capture card ?
Thanks!
Part Number: ADS5295EVM Hi Team,
I am working on an application where I want to test data capture from 16 analog channels (10MHz), using two ADS5295EVM and TSW1400EVM for data capture . I want to check whether this can be done. Any reference to how…
Hi Praveen,
I installed the LabVIEW 2017(eval) before a few of months. Probably I think this is the cause.
I removed all LabVIEW software on my PC, then re-installed the TI's GUI software. It works correctly!
