Part Number: ADS5404 Other Parts Discussed in Thread: ADS54T04 Hello,
Could you explain the difference between the ADS5404 and the ADS54T04?
Thank you.
Part Number: ADS5404 Other Parts Discussed in Thread: ADS5402 , DAC5688 Tool/software: For our forth coming EVB development for WiFi project we are looking for high speed ADC and DAC that can support variable sampling rates from 40 to 320Msps for ADC…
Part Number: ADS5404 Other Parts Discussed in Thread: TSW14DL3200EVM , ADC12DL3200EVM Hello. I try to get samples from ads5404 on the kintex7 fpga. I can't take samples without errors at maximum sample rate. Do you have example project for xilinx fpga…
Part Number: ADS5404 Other Parts Discussed in Thread: ADC3683 , ADS54J69 Hi Team,
I'm using an ADC with part number: ADS5404IZAY and interfacing the LVDS output with a Xilinx Zyn Ultrascale FPGA. The ADC board we designed has been interfaced with the…
Part Number: ADS5404
Please see below document. I am seeing a very poor response for the analog input circuit chosen for the ADS5404 evaluation board. Have anyone in TI or otherwise actually simulated this circuit?
www.dropbox.com/.../ADS5404_analog_input_simulations…
Part Number: ADS5404 I need to use three ADS5404s to sample 6 channel-125MHz IF signals with the function of SYNC,but when I process the sample data, I found that some channels is not SYNC with the orher channels,and the delay phase is 180° with the other…
Part Number: ADS5404 Hi,
Can we input AC coupled signal to SYNC pin directly?
In other words, are SYNC input pins biased common mode voltage internally?
Best Regards,
Kuramochi
Part Number: ADS5404 Hi,
SYNC pin voltage range is specified as below.
Though my customer send sync signal from FPGA, voltage range is not match as below;
FPGA LVDS Spec(1) Vodiff :247mV(min),350mV(typ),600mV(max)
FPGA LVDS Spec(2) Vocm :1.0V…
Part Number: ADS5404 Hi,
I am testing ADS5404 operation on a custom PCB at 500MSPS. I am using a 4MHz test CW signal to drive a single data converter channel.
I have enabled DC correction to remove the spurs at DC and Fs/2 as mentioned on page 23…
