Other Parts Discussed in Thread: ADS5545 , ADS6149 Hello all,
I am using the ADS5545 ADC in a design with a Virtex 5 FPGA.. We are using the 5545evm evaluation module (http://www.ti.com/tool/ads5545evm) for testing. I notice that board has a Spartan3…
Other Parts Discussed in Thread: ADS5545 Hi,
I am using the ADS5545 but I have a single ended source - what is the best way to convert from single ended to differential? Is there a nice app not or a single driver I could use?
Hi,
There was a screenshot in the test document that did not come through in copying and pasting into the posting. I am attaching the document itself. Also, back then we had a batch file that we would run that would handle the Xilinx JTAG programming…
Hi,
It didn't work, says 'No Device Found'. You can see the attached snapshot. You can see USB Serial Converter under USB Controllers at the same time but still it says no device found.
Yes, I used ADS5545 EVM template.
When I did scan using MProg…
JH,
The ADS4449 is a LVDS output device. You need to remove all series 22 Ohm resistors on the output data lines and the output clocks and replace them with a single 100 Ohm resistor that will be connected across every +/- pair 2746.Transformers.ppt…
Hi,
I've attached a zip folder of the Mprog utility that we use to program the USB device on the older EVMs. I renamed some of the file types so that they would not be stripped out as possible malicious code. exe and dll file types are sometimes striped…
Other Parts Discussed in Thread: ADS5545 I have noticed that in the factory configuration of the TSW4200 the clock for the ADS5545 is generated single ended in the CDMC7005 then buffered, filtered and then converted in a differential signal.
What is…
Other Parts Discussed in Thread: ADS5545 Hi, I want to use the TI_ADC_SPI_5p1 software together with my own PCB. A FTDI chip is there like on the ADS528x EVM. Which VID, PID and other data must be entered in the EEPROM of the USB device, to achieve that…
Yinon,
Yes, using a 1:N transformer will allow you to increase the signal swing without adding noise as this is a passive device. You will need to be careful when choosing a transformer as the linearity will vary from model to model. I have attached…
