Part Number: ADS5560EVM Dear Sirs,
we use the ADS5560EVM with 1 MHz sinus analog input signal on the SMA connector J6 (single-ended). The signal generator has a 50 Ohm output. After connecting the input signal collapses in half, viewed with the oscillograph…
Part Number: ADS5560EVM Other Parts Discussed in Thread: HSADC-SPI-UTILITY , , ADS5560 Dear TI experts,
i'm trying to set the registers of the ADS5560EVM through the HSADC-SPI-Utility Software. But get an Error as seen in the picture below.
I have…
Part Number: ADS5560EVM Dear TI-Team,
we're using the ADS5560EVM in conjunction with the TSW1405. Is there a way to get a continuous stream of data from the TSW1405 evaluation board and where can I tap the data? We would like to save the data separately…
Part Number: ADS5560EVM Other Parts Discussed in Thread: FMC-ADC-ADAPTER Hi,
I'd like to use sensor "VS-BV203" with FMC ADC EVM.
https://www.avnet.com/wps/wcm/connect/onesite/dc68331c-7a8d-440e-8d47-391e05d62296/KEMET-VS-BV203-B-And-VS-JV10A…
Part Number: ADS5560EVM Hi, TI expert
I would like to use ADS5560EVM for my project testing, and had one on my hand today.
but the mark of board is show the "REV C" , it is not mach with your www data ( http://www.ti.com/lit/ug/slau260/slau260.p…
Part Number: ADS5560EVM Other Parts Discussed in Thread: TIDA-00069 , ADS5560 , ADS4249 Dear TI expert,
I am looking for an evaluation platform for ADS5560EVM, in TI's document, it mentioned " High Speed ADC to FMC (Xilinx) Header Adapter Card " and…
Hello Kang,
Thank you for the Rev C schematic. I had already laid out the interface board, but fortunately can deal with connector J5 changes by modifying the schematic -- and only one jumper on the board. I will keep checking for the design package zip…
Other Parts Discussed in Thread: ADS5560 I am looking for a specifiction document for the ADS5560 which might give information like Analog input range/impdeance/bandwidth. I also need something for the clock input as well.
You are correct that many of the high speed ADC devices do not specifically specify PSRR; however, a clean supply is important to maintain best SNR and SFDR performance.
For best performance, it is best to use low noise LDO for power supply of the ADC…
