Part Number: ADS6144 Hi,
I am designing a board where an ADS6144 will be connected to a Cyclone 10GX FPGA. This FPGA (like many newer devices) does not have many 3V tolerant pins. I would like to use the LVDS interface of the ADS6144 and connect it…
Other Parts Discussed in Thread: ADS6144 Hi,
I have a KC705 board and an ADS6144EVM.So i bought only a FMC adapter, But i found there is not any setting file or F/W about ADS6144 in my High Speed Data Converter Pro.I`m not good at FPGA so i need some…
Hi,
Here are some more ponits based on the e-mail you mentioned. It sounds you have got the data from ADC into the receiver, but you can’t reconstruct the sine wave from the data collected. It sounds to me you should check following things, how you…
Other Parts Discussed in Thread: ADS6144 Using ADS6144 (14bit ADC)
I always write to the ADC after power on according to the figure below.
The output is configurated for LVDS but i get CMOS
If I configure the output for LVDS again at address…
TI,
To help me verify my design, how many points were taken to produce the following FFT shown in the spec sheet? Is this only an FFT or was a PSD calculated? Any help is apprecitated.
Regards,
Nelson
Other Parts Discussed in Thread: ADS6143 , ADS6142 , ADS6144 Hi, Could somebody answer my question, please. Is there any way to digitize a signal with the bandwidth 10 MHz (single channel) directly at IF, which is 70 MHz for further processing in DSP…
