Other Parts Discussed in Thread: ADS6148 , ADS6129 Hi there,
I have a question about ADS6148 self-test mode.
My customer is using ADS6148 and meets an issue about digital error code of ADS6148.
the customer mentions that he will see an digital…
Hi,
What is IHM? I don't recognize that acronym. You are looking at the FFT or the time domain data on HSDCPro?
I think I need to make a new device ini file for you to add to the HSDCPro installation. You are using the device selection ADS614x? That…
Other Parts Discussed in Thread: ADS6148 , AFE5808A Hi,
i'm trying to use the TSW1200 (ADC: ADS6148) in Matlab, but i couldn't find the m-Files. The manual told me, that the files are stored on the CD, but there's no CD delivered with the TSW1200. I…
We are using the ADS6148 in conjunction with ADS6242 on separate banks of the FPGA. While the faster ADS6148 needs 1.8V on its DRVDD, the ADS6242 was also powered from 1.8V via LVDD. This was a misconception and resulted in the described. However it is…
Other Parts Discussed in Thread: ADS6148 , ADS1248 Hi,
I want to evaluate an analog part with an ADS6148EVM. (The Analog device is part of measurement system, with uses the ADS6148, too!). I connect the ADS6148EVM with a TSW1200 for the communication…
ALB,
Is your EVM a Rev C board? If so I have attached the schematic. Please make sure all jumpers are set per the board photo I am sending. Take a scope probe (diff probe would be better) and monitor the ADC input across R21 and R26. You should see…
Jin,
The schematic looks good for the most part. Please do the following:
1. Install R364 to provide a path to GND.
2. Do not use R361, R362, and R363 wit the ADC_VCM output.
3. Make sure DRVDD and AVDD are 3.3V.
4. Do not need to route ADC_CLKOUTM_F…
Hello Jim,
Apologies for the late reply. I have been traveling and have now just starting to catch up to all the E2E questions.
The revision C of the schematic is attached. The major change on this revision is that we have replaced U15 from a 16-bit…
