• ADS7066: Delay time

  

  Danilo A.

  TI Thinks Resolved

  Part Number: ADS7066 Other Parts Discussed in Thread: ADS8900B Hi Team, Can you please help us with this inquiry of our customer. From the datasheet, the D_CKCS: SCLK launch edge to (next) data is valid on SDO. What is the launch edge, leading or trailing…

  • 22 days ago
  • Data converters
  • Data converters forum

• ADS7066: Question about driving ads7066

  

  Jordan Schultz

  TI Thinks Resolved

  Part Number: ADS7066 Other Parts Discussed in Thread: ADS8168 , OPA325 Hi, I have an amplifier (non-TI) with a GBW of 1MHz om the front emd used to drive the ADC, and am getting a little mixed up about the external RC required to drive the input of the…

  • 3 months ago
  • Data converters
  • Data converters forum

• ADS7066: RC(kickback) filter selection

  

  Mark Philip Felipe

  TI Thinks Resolved

  Part Number: ADS7066 Hi Team, seeking some support. Using the ADS7066 for a data acquisition application. I have a MAX41400 amplifier for 10uV-10mV(5Hz-5KHz) signal amplification and this goes to the RC(kickback) filter before the input of the ADC. the…

  • 29 days ago
  • Data converters
  • Data converters forum

• ADS7066EVM-PDK: Using the evaluation board of ADS7066 for ADS7067

  

  Roee Kimchi

  TI Thinks Resolved

  Part Number: ADS7066EVM-PDK Other Parts Discussed in Thread: ADS7067 , ADS7066 Hi, I have the Evaluation board of ADS7066, and also I have ADS7067. I wanted to ask if it is possible to still use the TI GUI after replacing these two ADCs on board? does it…

  • 1 month ago
  • Data converters
  • Data converters forum

• ADS7066: ADS7066

  

  John Masciola

  Part Number: ADS7066 I have a ADS7066 chip and the ADS7066 EVM. The chip works fine when running with the EVM platform and TI software. When we connect the chip into our system (unplugging the EVM from the platform and attaching to our circuit which is…

  • 7 months ago
  • Data converters
  • Data converters forum

• ADS7066: SDO State with AVDD Off

  

  Shinichi Yokota

  TI Thinks Resolved

  Part Number: ADS7066 Hello, What's the state of ADS7066's SDO pin while the AVDD (analog supply) is off but the DVDD is on? It looks the SDO level is still High and disturbs SPI communication of the other SPI slave devices on a shared SPI bus.…

  • 7 months ago
  • Data converters
  • Data converters forum

• ADS7066: Calibration Process

  

  RJ

  TI Thinks Resolved

  Part Number: ADS7066 Hi Team, Can you provide a little bit more information on the ADC Offset Calibration function on the ADS7066? Are there any expected input conditions that we need to hold when we initiate the offset calibration, or is it an internally…

  • 9 months ago
  • Data converters
  • Data converters forum
Answered

• ADS7066: Auto Sequence Question

  

  RJ

  Resolved

  Part Number: ADS7066 Hello, If I am running in auto-sequence mode, do I need to clock 0x00 into SDI for every transfer, or are certain bits “don’t care” like they are during On-The-Fly mode?

  • Resolved

  • 10 months ago
  • Data converters
  • Data converters forum

• ADS7066: The values of single-point continuous sampling ADC differ greatly

  

  Ao Sun

  Part Number: ADS7066 Other Parts Discussed in Thread: OPA333 ads7066support.doc

  • over 1 year ago
  • Data converters
  • Data converters forum

• ADS7066: Could ADS7066 support 5 part in daisy chain mode and daisy chain communication sequence

  

  Will Wang47

  TI Thinks Resolved

  Part Number: ADS7066 Hi team, As mentioned, could ADS7066 support 5 pcs in daisy chain mode? Does the communication sequence used as follow? Each byte need a s eparate CS control signal? Best Regards, Will

  • over 1 year ago
  • Data converters
  • Data converters forum

Didn't find what you are looking for? Post a new question.